User manual HPI SAVAGE XL

[. . . ] If the wire is frayed or worn, a short circuit can cause a fire or burn. *AC Charger will not include in RTR model for Asia and Oceania specificatoin. Equipment needed - 8 pieces of AA Alkaline Batteries for the transmitter Benötigtes Zubehör - 8 AA Trockenbatterien für den Sender. Please read the instructions before running. [. . . ] If you hear tone signal, the automatic set-up of the speed control is ready. Do not operate the throttle trigger on the transmitter yet to prevent malfunction caused by incomplete set-up. Make sure no one else is using the same radio frequency as you are using. Check the radio system and range before every driving session. To properly check the range, have a friend hold the truck and walk to the farthest distance that you plan to operate your model. Operate the controls to make sure the model responds correctly. Do not operate the model if there is any problem with the radio system. If you switch on the R/C car first before the transmitter, you may lose control of the R/C car. Pulling the throttle trigger should move the car forward and pushing the throttle trigger should stop or move the car in reverse. The car will start running in reverse 2 seconds after braking. Look at the car from the top to check if the front tires are pointing straightforward. Turn off receiver first, then turn off transmitter. Always disconnect the battery connector from the speed control connector after driving. After you finish driving, remove dirt and tire debris from the chassis with rag, a soft brush or air blower and see if there are any damaged or worn parts. This is an important part of your car maintenance. Use rag to remove dirt and tire debris from the chassis. Make sure all screws are properly tightened. If R/C car does not move or you have no control, see below. Change your radio frequency to the one no one else is using, wait until the driver using the same radio frequency finishes driving, or drive your car at a different place. The car does not follow There is not enough power in the transmitter or receiver batteries. Someone else is using the same radio frequency as you are using. Replace the motor pinion gear with another one with less teeth. [. . . ] This section shows how to convert your E10 from touring version to drift version. Use the wheel hubs and screws shown above for a 200mm body. This section shows how to convert your E10 from drift version to touring version. Use the wheel hubs and screws shown above for a 200mm body. [. . . ]