User manual HUBBELL LIGHTING MIC-GS

[. . . ] Should this occur, the unit will not operate properly. In this case, remove the MD and wait for about an hour until the moisture evaporates. Replace labels that are begining to peel away from the MD. Be careful not to splash juice or other soft drinks onto the unit or discs. [. . . ] Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Do not reach into the changer to avoid injury. Cautionary notice for opening and closing the door If you press on the transparent window too hard, it may break or cause injury. (If the ignition key is in the OFF position, the light automatically goes out after one minute. Do not insert an MD with the label facing downwards. Make sure the MD's shutter is closed before inserting it into the magazine. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. And foreign patents licensed from Dolby Laboratories. Design and specifications subject to change without notice. Choose the mounting location carefully, observing the following: -- Do not install the unit where; · It will interfere with normal driving operations. It will jam any working parts of the car. It will get the wires under a screw, or caught in moving parts. Be sure to use only the supplied mounting hardware for a safe and secure installation. * Connect the Bus cable to its terminal with unit's V mark and Bus cable's v mark aligned. Under the passenger's seat or floor installation / Installation sous le siège du passager ou sur le plancher Decide on the installation position, and remove any dirt or stains from that surface. Place the changer onto the mounting pad 2, then peel the backing and stick 2 to the floor. Be sure to insert each connector securely, as vibration through driving may cause a poor connection. [. . . ] If you pull out by the cable, the cable may become loose. For connecting two or more changers, the source selector XA-30 (optional) is necessary. Make cuts in the carpet with a box knife. How to detach and attach the protection cover Push in and slide the protection cover off. [. . . ]