User manual HUBBELL LIGHTING QUICK-ZONE(CH-B

[. . . ] That the inlet and draining pipes are connected correctly. Never use hoses that have already been used, always use the new ones provided with your machine. That the washer is levelled properly; something worth checking for the life of your washer and the quality of your wash; 4. That the drum's fixing screws have been removed from the back of the washer. 7. [. . . ] Or maybe due to a general failure in your entire area. Is the washing machine door closed properly?For safety reasons, the washing machine cannot work if the door is open or not shut properly. If it is, then a programmed start has been set. Is the programmed start knob, in the correct position for those models concerned?For safety reasons, if the washing machine does not load water, it cannot start a wash cycle. Before calling, read the following But where did all the water go? Simple: with the new Ariston technology, you need less than half of it, to get good results on twice as much!This is why you cannot see the water through the door: because there is little, very little of it, to respect the environment yet without renouncing maximum cleanliness. And, on top of that, you are also saving electricity. The programme selector knob keeps turning?Wait a few minutes for the drain pump to empty the tub, switch Margherita off, select one of the symbols stop/reset , then switch it back on. If the knob continues to turn, call for assistance because it is showing an anomaly. RIGHT Turn off the water supply after use. This will eliminate the possibility of leakage. To check it, turn off the water supply, unplug the washing machine and follow the instructions on page 12, or call for technical assistance. Always get assistance from authorised technicians and always insist on original spare parts. The tract of the drain hose must be as straight as possible. Make sure the drain hose is not squashed or kinked. Is the washing machine’s drain duct clogged?Is there an extension of the drain hose?If so, is it positioned incorrectly, blocking the water flow?Is there space between the machine and adjacent units?If it is not a built-in model, the washing machine will oscillate a bit during the spin cycle. A few cm of space should therefore be left around it. Is the detergent appropriate for machine washing? [. . . ] Never pull on the supply cable or the washing machine to disconnect it from the wall socket: it is extremely dangerous. While the appliance is functioning, do not touch the drain water as it could reach very high temperatures. The appliance door, during wash cycles, tends to become hot; ensure that children do no touch it. Never force the washing machine door because this could damage the safety lock which prevents accidental opening when the nachine is working. [. . . ]