User manual HUBBELL LIGHTING SLS INTEGRAL FIXTURE

[. . . ] Refer to steps 3 and 4 of "Connections" of the operating instructions supplied with this receiver for details on other connections and other components. This receiver is equipped with function for converting video signals. * You cannot use the surround back speakers and the front high speakers simultaneously. [. . . ] The illustrations above show an example of a 7. 1 channel speaker system (seven speakers and one subwoofer) configuration. Refer to the operating instructions supplied with the receiver and the other side of this guide. Connect the AC power cord (mains lead) to a wall outlet. Connect the speakers according to the number and type of your speakers. Use speaker cords, which are appropriate for the width of the room. The speaker cord may have different colors or markings on them. To make the correct connection, decide which to connect to the plus (+) and minus (­) terminals on the speaker. However, you can change those settings in the Speaker Settings menu. Save the measurement results first, then try to change the settings if you want. Doing so may damage the receiver and the microphone. Use a stool or tripod so that the optimizer microphone remains at the same height as your ears. When a subwoofer is connected, turn on the subwoofer and turn up the volume beforehand. Turn the LEVEL to just before the mid-point. If you connect a subwoofer with the crossover frequency function, set the value to maximum. If you connect a subwoofer with an auto standby function, set it to off (deactivated). [. . . ] If you connect a subwoofer with an auto standby function, set it to off (deactivated). The Auto Calibration function allows you to measure the following: speaker connections, polarity of speakers, speaker distance, speaker size, speaker level, frequency characteristics. You should set up each component so that the sound is output from speakers correctly when you play back a connected component. [. . . ]