User manual HUBBELL LIGHTING TCA-W2

[. . . ] How to use your appliance Gas burners The burners differ in size and power. Choose the most appropriate one for the diameter of the cookware being used. The burner can be regulated with the corresponding control knob "M" by using one of the following settings: Off High flame Low flame The symbols near the knobs show the position of the relative burner on the hob. The burners are fitted with automatic ignition and thermocouple safety device, which automatically cuts off the gas from the burner in a few seconds if the flame accidentally goes out during operation. [. . . ] • The cookware is centered correctly on the burner or electric hot plate. € The support grids have not been inverted. If, despite all of these checks, the cooktop does not function properly and problem persists, call the nearest Merloni Elettrodomestici Customer Service Centre, informing them of: - The type of problem. - The abbreviation used to identify the model (Mod. Never call upon technicians not authorized by the manufacturer, and refuse to accept spare parts that are not original. Safety Is a Good Habit to Get Into • This appliance is designed for non-professional use in the home and its features and technical characteristics must not be modified. These instructions are only valid for the countries the symbols for which appear on the manual and the serial plate. The electrical system of this appliance is safe only when it is correctly connected to an adequate earthing system, as required by current safety standards. The assistance of qualified personnel must be called upon in the following cases: - Installation (in accordance with the manufacturer's instructions); - When in doubt about the operation of the appliance; - Replacement of the electrical outlet becuase it is incompatible with the plug. Contact service centers authorized by the manufacturer in the following cases: When in doubt about the condition of the appliance after having removed the packing; - Damage to or replacement of the power supply cable; - In the case of a breakdown or malfunction: ask for original spare parts. It is recommended that you follow the guidelines below: - Only use the appliance to cook food, avoiding all other uses; - Check the condition of the appliance after it has been unpacked; - Disconnect the appliance from the power supply in the event of malfunction and always before cleaning or maintenance; - When not in use, disconnect the appliance from the power supply and turn off the gas valve (if present); - Always check to make sure that the control knobs are on the “•”/”o” setting when the appliance is not in use; - Cut the power supply cable after disconnecting it from the electrical mains when you decide to no longer use the appliance. € If it is impossible to fit a hood, the use of an electric fan is permitted, either installed on a window or on an external wall, which must be switched on at the same time as the appliance. 2 combustion of the gas and for ventilating the same room. Air must be taken in naturally through permanent apertures made in the outside walls of the room or through single or branching collective ventilation ducts in compliance with the standards in force. The air must be taken directly from the outside, from an area far from sources of pollution. The ventilation aperture must have the following characteristics (fig. 3A): · Total free cross section of passage of at least 6 cm² for every kW of rated heating capacity of the appliance, with a minimum of 100 cm² (the heating capacity is indicated on the rating plate); · It must be made in such a way that the aperture, both on the inside and outside of the wall, cannot be obstructed; · In such a way that the above-mentioned free section is not reduced; · It must be situated as near to floor level as possible. detail A Adjacent Room Room to be Vented A Examples of ventilation holes for comburant air. Enlarging the ventilation slot between window and floor. (exclusively for cooking appliances) Directly to the Outside Kitchen ventilation The air flow into the room where the appliance is installed must equal the quantity of air that is required for regular 12 The air inflow may also be obtained from an adjoining room, provided the latter is not a bedroom or a room where there is a risk of fire, such as garages, mews, fuel stores, etc. and is ventilated in compliance with the standards in force. Air from the adjoining room to the one to be ventilated may be made to freely pass through permanent apertures with a cross section at least equal to that indicated above. [. . . ] When installing above a built-under oven without forced cooling ventilation, a wooden panel “A” (fig. 4) should be installed beneath the hob as insulation, positioning it at a minimum distance of 15 mm from the hob housing. For trouble-free operation of the appliance set into kitchen units, the minimum distances indicated in fig. 5 180cm² 15mm A The hob has a protection rating Y against overheating, in accordance with standard EN60335-2-6. [. . . ]