User manual HUGHES & KETTNER BASSKICK 505

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HUGHES & KETTNER BASSKICK 505. We hope that this HUGHES & KETTNER BASSKICK 505 user guide will be useful to you.

Lastmanuals help download the user guide HUGHES & KETTNER BASSKICK 505.


Mode d'emploi HUGHES & KETTNER BASSKICK 505
Download
Manual abstract: user guide HUGHES & KETTNER BASSKICK 505

Detailed instructions for use are in the User's Guide.

[. . . ] For the combo version, you can connect one 8 ohm cabinet, and for the head, a maximum of two 8 ohm speaker cabinets in parallel. FX RETUIRN: Connect this jack to the FX processor's OUTPUT jack. FX SEND: Connect this jack to the FX processor's INPUT jack. MAINS SOCKET: Connect the included Euro-norm mains cable to this socket. The fuse bracket is integrated in the socket; ensure you use specified replacement fuses only! LINE OUT: Use this balanced output to send signals to a mixing console or additional power amp. The signal routed to this jack is affected by the voicing section but not the MASTER control. I FOOTSWITCH: Connect a standard footswitch here to remotely switch the SOUNDMATRIX function located on the front panel. 4 BASSKICK-MANUAL . . , , 4=% + 2. 0 STANDARD SETUP /CABLE CONNECTIONS Mixing Console FOOTSWITCH FX Devices El I LINE OUT t MATRIX ON/OFF SEND RETURN t1 OUT A Phones BassKick 505 / 707 Sound II: 3. 0 OPERATING THE BASSKICK 505/507 3. 1 THE SOUNDMATRIX The SOUNDMATRIX is a new type of sound filtering system that lets you dial in diverse basic tonal settings while ensuring the frequency response is always musical. [. . . ] If the LED illuminates with every note you play, the BassKick's preamp is saturated. In this case, adjust the gain and/or treble controls to a lower setting. The midrange setting: The following procedure is especially effective for dialing in the desired midrange tone: - To tune the midrange, turn the MID LEVEL control all the way up so you can hear the desired frequency bandwidth properly. - Select the desired frequency via the MID FREQ. Yqu will hear a wah-wah effect as you are turning the knob; the selected frequency range is also amplified. - Now you can use the MID LEVEL control to amplify or attentuate the desired frequency range. If you leave the MID LEVEL control in the 12 o'clock position for a given frequency, that frequency will not be influenced. 3. 3 THE BASSKICK 505 TWEETER The BassKick combo is equipped with a 15" woofer and a dynamic tweeter. This tweeter is precision-tuned to produce contemporary bass sounds replete with loads of upper register harmonics. The"TREBLE" control's center frequency was selected to enable you to dial in exactly the amount of brilliance you want in your sound. You can also activate and deactivate the tweeter as desired via the "HF-HORN ON/OFF" switch. The switch is located on the right side of the combo, above the speaker, and is accessible through an opening in the speaker grille. 4. 0 SERVICE AND PREVENTIVE MAINTENANCE The BassKick amps do not require service of any type. However, there are a few precautions you should heed. - Ensure all peripheral devices, cords and cables are in a state of good repair. Defective speaker cables (shorted cables, loose connections) are by far the most common cause of power amp failure. - Ensure air can circulate around your amp's ribbed ventilation ducts, especially when you have installed the amp in a rack. - Avoid mechanical shocks and exposure to extreme heat, dust and especially moisture. -When connecting peripheral devices, always heed the proper safety precautions. Never connect speakers with inadequate impedances (ohms), and never connect devices with high output signal levels (e. g. - Ensure you have the correct AC power rating available before you plug in the amp. If in doubt, ask the venue's sound technician or stage hand. You should also have a qualified technician replace internal fuses. Use a brush to clean the flock covering (combo version), and a soft damp cloth for all metal parts. BASS-KICK-MANUAL 5. 0 POSSIBLE ERROR SOURCES/ TROUBLE-SHOOTING The BassKick is not getting any power: - Check the mains cable to see if it is connected properly. [. . . ] - The connected device's input circuit is unbalanced and an electrical or magnetic field is causing interference. Use a balanced input or situate the cables to reduce interference to a minimum. - The grounding of the connected devices are causing a ground loop. Do not sever the ground of the connected devices under any circumstances! [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HUGHES & KETTNER BASSKICK 505

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HUGHES & KETTNER BASSKICK 505 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag