User manual HUMAX 5301

[. . . ] Freeview+ HD explained: • Accurate recording The start and end times of scheduled recordings will track the signal meaning the recording will start and stop at the times sent by the broadcasters. If a programme starts early or runs late the record time will automatically be adjusted to record the whole programme. Series Recording If a programme you wish to record is in a series, you can now record the whole series. If the programme changes to a different day or time the product will track these changes and still record the programme. [. . . ] 54 Menu On/Off Select Confirm Enter 0~9 Installation Antenna Power MENU J Settings J Installation J Antenna Power English Active antenna is a portable or indoor antenna which needs power supply from the product because it does not have power cord for itself. Connect an active antenna to the ANTENNA IN on the rear of the product. H On: 5V power is supplied from the active antenna cable. H Off: No power supplied Note: Most domestic aerial installation will not require the Antenna Power option to be switched on. Please check with your aerial installer if this is required for your aerial. You will be prompted to enter the password. If you have forgotten your password, please contact Humax Customer Support. • To format the HDD , mark Format HDD. Warning: • Please note that once you perform Factory Default, all user configuration/settings will be reset to the Factory settings. After completing the factory default, the installation wizard will appear automatically in a few seconds. Menu On/Off Select Confirm Enter 0~9 55 System In System, system information, signal detection, power management , common interface, data storage and internet setting are available. note: Press the MENU or EXIT button to exit. Press the BACK button to return to the previous screen. system Information MENU J Settings J System J System Information The system information is displayed. Signal Detection MENU J Settings J System J Signal Detection You can check the signal strength and quality of the searched channels. Note: We recommend that the Signal Strength is above 30% and the Signal Quality is above 70% in order to receive the channels without picture/sound breakup. 56 Menu On/Off Select Confirm Enter 0~9 System Power Management MENU J Settings J System J Power Management Setting Power Saving in Standby You can minimise the standby power consumption to below 1W. Select On to deactivate the certain features and minimise the power consumption. Note: When Power Saving in Standby is switched On the Time on the front display will not appear when in standby, nor will the Antenna Out loop-through the signal to a connected device. Setting Automatic Power Down English The receiver automatically enters standby mode for power saving if no user interaction occurs for 3 hours. Select On to enter standby mode automatically if no user interaction occurs for 3 hours. note: The message will be displayed before entering standby mode. [. . . ] If the distribution and/or use of the Library is restricted in certain countries either by patents or by copyrighted interfaces, the original copyright holder who places the Library under this License may add an explicit geographical distribution limitation excluding those countries, so that distribution is permitted only in or among countries not thus excluded. In such case, this License incorporates the limitation as if written in the body of this License. The Free Software Foundation may publish revised and/or new versions of the Lesser General Public License from time to time. Such new versions will be similar in spirit to the present version, but may differ in detail to address new problems or concerns. [. . . ]