User manual HUMAX CX-FOX C

[. . . ] Notice ** Copyright (Copyright © 2006 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. ** Warranty This warranty does not cover parts which may become defective due to misuse of the information contained in this manual. ** Trademarks VIACCESSTM is a trademark of France Telecom. CryptoWorks (TM) is a trademark of Philips Electronics N. V. Nagravision is a registered trademark of Kudelski S. A. Conax is a trademark of Telenor Conax AS. [. . . ] If there are multiple channels, use button to move to PAGE-/PAGE+ channels by page. Also, you can enter your desired channel number using the NUMERICAL (0~9) button on the remote controller to move to the channel directly. Select your desired programme, and press the OK button. Then you can watch the programme if it is on air, or you can reserve it if it is the following programme. button in the selected programme to view Extended Information for the 5. Viewing Guide Information by Groups You can view programme information for desired channel list by groups. Press the Red button to display the channel list group. Select your desired channel list group using the button to display the appropriate sub-group. Move the cursor to the sub-group using the button, select your desired sub-group using the button, and then press the OK button. The Programme Guide for selected channel list is displayed. GB 37 6. Viewing Programme Information Using Time Bar You can quickly search for your desired time zone using the Time bar. Press the Green button to display Time Bar. button, and press the OK button to move 3. Select the Time Bar button using the as your desired amount of time. If you press the button repeatedly, the same operation is repeated. Now Moves to the current programme where the cursor is located. Moves to the previous programme or 30 minutes before. Moves to the next programme or 30 minutes after. button and press the OK button to exit the Time Bar. 3. Reserving a Programme You can automatically reserve your desired programme by selecting the scheduled programme and pressing the OK button. Select the desired programme and press the button. The following message will be OK displayed. [. . . ] Check whether the Smart Card is damaged. If the product has been turned off for a longer time (standby or power off), please wait for authorization, up to 60 minutes. GB 63 13. Troubleshooting ** 13. 2 Error Message Error message No or bad signal Possible causes The cable is not connected. The channel is scrambled or not available. [. . . ]