User manual HUMAX DIGI PLUS 4

[. . . ] Digital Set-Top Box DIGI+IV User's Manual The default password is 0000. Notice Thank you for purchasing a HUMAX product. Please read this user's manual carefully to be able to safely install, use and maintain the product at maximum performance. Keep this user's manual next to your product for future reference. The information in this user's manual is subject to change without notice. Copyright (Copyright © 2008 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. Warranty The warranty does not cover parts which may become defective due to misuse of the information contained in this manual. Trademarks Nagravision is a registered trademark of KUDELSKI S. A. Warnings, Cautions and Notes Throughout the whole manual, pay special attention to the following marks that indicate hazardous situations. [. . . ] DUAL ROOM PORT Connects to the master or slave STB using a LAN cross cable. RF OUT Connects to the RF IN of the TV using an RF cable. RF IN Connects to the general aerial antenna or cable. GB10 1. Before Using the Product 1. 5 Remote Control 1 1. TV/RADIO Switches between TV and radio modes. 2 3. NUMERIC(0-9) BUTTONS Enters a TV/radio channel number or menu option number. LIST (SUB-PAGE) Displays the channel list. BACK Returns to the previous channel or menu option. ARROW BUTTONS Changes the channel or moves the cursor up, down, left or right. OPT+(OPTION) Displays the channel attributes while watching a programme. WIDE Changes the display format. 3 4 5 6 7 8 9 10 11 GB11 1. MUTE Mutes or unmutes the audio temporarily. 12 13 13. POWER Switches between operation and standby modes. GUIDE (HOLD) Displays the programme guide. EXIT Exits all On-Screen Display (OSD) screens. 14 15 16 16. OK Selects a menu, or confirms the selected operation. Setup 2. 3 Connecting the TV and VCR 1. Connect the RF OUT of the product and the aerial input of the VCR using an RF cable. Connect the aerial output of the VCR and the aerial input of the TV using an RF cable. Note: · Connect your aerial or cable to the RF IN to watch analogue channels. · Tune the TV or VCR to an UHF channel if the product is connected to the TV or VCR using an RF cable. RF Cable VCR SCART VIDEO L AUDIO R VCR Antenna IN VCR Antenna OUT S/PDIF RF Cable TV SCART VIDEO L AUDIO R TV Antenna IN TV Antenna OUT S/PDIF GB18 2. Setup 2. 4 Connecting Audio System Select the most appropriate procedure for your convenience. · · Connect the product and the audio system using an RCA cable. [. . . ] Channel Type: Select the channel type. GB29 7. Other Search You can directly enter the packet ID value or search channel using SMATV. 5. Update You can update the software. 6. Default Setting Restores the product to the default settings. 7. 4 System & Games 1. [. . . ]