User manual HUMAX HD-FOX T2

[. . . ] HD Digital Receiver User's Manual HD-FOX T2 The default password is 0000. Notice English Thank you for purchasing a HUMAX product. Please read this user's manual carefully to be able to safely install, use and maintain the product at maximum performance. Keep this user's manual next to your product for future reference. The information in this user's manual is subject to change without notice. Copyright (Copyright © 2010 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. Warranty The warranty does not cover parts which may become defective due to misuse of the information contained in this manual. Meaning of Symbols To reduce the risk of electric shock, do not remove cover (or back). [. . . ] Check the signal levels and adjust your antenna if the level is too low. The signal level may be affected by weather conditions. 2. Poor picture/sound quality Note: If the antenna is covered with snow or the RF is weakened by heavy rain, the condition of the sound and picture may temporarily be poor. However, the poor sound and picture quality due to weather conditions cannot be accepted as a malfunction of product. · · · · · · [Satellite] Check that your dish alignment is correct. [Satellite] Change the satellite dish for a larger one as this will increase the signal levels received. [Satellite] Replace the LNB with a lower noise factor in cases where the noise factor is too high. [Satellite] Replace the LNB with a new one in case it is damaged or out of order. [Terrestrial] Adjust the antenna direction to get a better picture. [Terrestrial] Set the antenna power in menu to On, if you use the active antenna to improve the reception. (where applicable) Check that your AV cable is connected correctly. Check the volume levels of your TV set and the product. Check audio type or soundtrack option in the AV menu. (where applicable) To control the product, the top end of the remote control should point directly towards the receiving part of the product. Remove and reinsert the batteries in the remote control. 4. No or poor sound · · · · · · 5. Remote control does not operate. 48 Appendix · · · · · · · · English Replace the batteries in the remote control for a new set. Set the remote control to STB or PVR mode, if you are using the universal remote control. (where applicable) Check that no previous reservations are conflicting with the new reservation. Satellite: Make sure that the antenna setting in the menu is correct. Terrestrial: Make sure that the antenna is connected correctly. Terrestrial: Use the appropriate antenna capable of receiving VHF or UHF channels for your area. If the product does not show a message requesting update, this means no software is available. [. . . ] The Free Software Foundation may publish revised and/or new versions of the Lesser General Public License from time to time. Such new versions will be similar in spirit to the present version, but may differ in detail to address new problems or concerns. Each version is given a distinguishing version number. If the Library specifies a version number of this License which applies to it and "any later version", you have the option of following the terms and conditions either of that version or of any later version published by the Free Software Foundation. [. . . ]