User manual HUMAX HD-RFOX T2

[. . . ] HD Digital Recorder User's Manual HDR-FOX T2 The default password is 0000. Notice English Thank you for purchasing a Humax HDR-FOX T2 Freeview+ HD product. Freeview+ HD explained: · Accurate recording The start and end times of scheduled recordings will track the signal meaning the recording will start and stop at the times sent by the broadcasters. If a programme starts early or runs late the record time will automatically be adjusted to record the whole programme. Series Link If a programme you wish to record is in a series, you can now record the whole series. If the programme changes to a different day or time the product will track these changes and still record the programme. [. . . ] Press the BACK button to return to the previous screen. System Information MENU Settings System System Information The system information is displayed. Signal Detection MENU Settings System Signal Detection You can check the signal strength and quality of the searched channels. Note: We recommend that the Signal Strength is above 30% and the Signal Quality is above 70% in order to receive the channels without picture/sound breakup. Menu On/Off Select Confirm Enter 0~9 56 System Power Management MENU Settings System Power Management English Setting Power Saving in Standby You can minimise the standby power consumption to below 1W. Select On to deactivate the certain features and minimise the power consumption. Note: When Power Saving in Standby is switched On the Time on the front display will not appear when in standby, nor will the Antenna Out loop-through the signal to a connected device. Setting Automatic Power Down The receiver automatically enters standby mode for power saving if no user interaction occurs for 3 hours. Select On to enter standby mode automatically if no user interaction occurs for 3 hours. Note: The message will be displayed before entering standby mode. If no selection is made for 30 seconds, the receiver enters standby mode automatically. Common Interface MENU Settings System Common Interface The common interface information is displayed. Menu On/Off Select Confirm Enter 0~9 57 System Data Storage MENU Settings System Data Storage You can check the size of the internal HDD or external USB storage device. Select storage to display the details for the storage. To format the selected storage, select Format Storage. If you select Yes, you will be prompted to enter the password. Note: · The default password is 0000. If you have forgotten your password, please contact Humax Customer Support. · Supported Features according to USB file system. Ext3: Read, Copy (Digital TV/Radio, MP3, JPEG, XviD) FAT: Read, Copy (Digital TV/Radio, MP3, JPEG, XviD) NTFS: Read (MP3, JPEG, XviD) Internet Setting MENU Settings System Internet Setting Configuring IP (LAN) 1. You can configure the Ethernet setting options. DHCP: Apply the options according to the DHCP. Manual: Enter the options manually, 2. Note: When entering the IP address manually, enter 3 digits in a row. Menu On/Off Select Confirm Enter 0~9 58 Appendix Specification Tuner & Channel Input Connector Frequency Range Signal Level Demodulation Mode FEC Mode Guard Intervals English IEC 169-2 Female 470 MHz to 862 MHz -70 to -10 dBmV OFDM DVB-T : 2K, 8K DVB-T2 : 1K, 2K, 4K, 8K, 16K, 32K DVB-T: 1/2, 2/3, 3/4, 5/6, 7/8 DVB-T2: 1/2, 3/5, 2/3, 3/4, 4/5, 5/6 DVB-T : 1/4, 1/8, 1/16, 1/32 DVB-T2 : 1/4, 1/8, 1/16, 1/32, 1/128, 19/128, 19/256 Audio/Video Decoding Audio Decoding Audio Mode Video Decoding Video Format Video Resolution Dolby Digital Plus Single channel/Dual channel/Joint stereo/Stereo HD MPEG2 /SD MPEG2 / MPEG4(H. 264/AVC) 4:3, 16:9, Letter Box 1080p, 1080i, 720p, 576p, 576i Memory Flash Memory RAM EEPROM 32 MB MB 320 MB 8 KB Audio/Video In/Out Video Audio TV-SCART, RCA, HDMI/HDCP TV-SCART, Audio L/R, S/PDIF (Digital Audio Output) Data In/Out USB RJ-45 USB 2. 0 Host (5 V 500mA Max. ) Ethernet 10/100 Mbps Hard Disk HDD 500 GB / 1 TB (Optional) 59 Appendix Power Supply Input Voltage Type Power Consumption Protection 90-250 V a. c. , 50/60 Hz SMPS Max. 28 W (Standby: Under 1 W) Separate internal fuse. The input should be protected against lightning. Physical Specification Size (w/h/d) Weight Operating Temperature 380 mm x 55 mm x 252 mm 2. 8 Kg 0 °C to +45 °C Note: The specifications are subject to change without notice. Service and Support Information concerning troubleshooting, software upgrade and product support is provided in the following websites and call centers. Should your product require warranty service, please contact HUMAX to obtain the appropriate authorization. HUMAX Call Center Tel: Opening Hours: E-mail: Website: Language: 0844 669 8800 Mon - Fri 09:00 ­ 17:30 (excluding Bank Holidays) uksupport@humax-digital. co. uk www. humax-digital. co. uk English UK 60 Appendix Safety Warning English This product has been manufactured to comply with international safety standards. Please read the following safety precautions carefully. Safety Instructions and Precautions 1. MAINS SUPPLY · · · · Operate this product only from the type of power supply indicated on the marking label. [. . . ] The Free Software Foundation may publish revised and/or new versions of the Lesser General Public License from time to time. Such new versions will be similar in spirit to the present version, but may differ in detail to address new problems or concerns. Each version is given a distinguishing version number. If the Library specifies a version number of this License which applies to it and "any later version", you have the option of following the terms and conditions either of that version or of any later version published by the Free Software Foundation. [. . . ]