User manual HUMMINBIRD AS PC2

[. . . ] You will need a PC with the following minimum specifications: Windows95/98/ME, NT4. 0 sp6, 2000 Pro, XP Home, XP Pro 32 MB RAM 20 MB free disk space Pentium or Celeron class processor An available 9-pin serial port Monitor capable of running at a resolution of 800 x 600 or higher. Note: You must have Internet access with this PC in order to perform the Humminbird software installation from the website; high-speed connectivity is not necessary, although a dial-up connection may slow down the initial HumminbirdPC software download. If you do NOT have Internet access, please contact our Customer Resource Center (334-687-0503) to obtain a CD-ROM containing the HumminbirdPCTM software application. [. . . ] Follow the prompts provided by the HumminbirdPCTM Setup Wizard (as shown in the sequence of Setup Wizard screen illustrations) to install the application on your PC. Note: When you have finished this procedure, you may be asked to re-start your PC. For WindowsNT/2000/XP users, it will depend on the user permissions that are assigned to you on that computer. A CD-ROM version of the HumminbirdPCTM software is available upon request from the Customer Resource Center*, and contains the HumminbirdPCTM application and all of the software necessary to install it on your PC. Follow these steps to install the software onto your PC from the CD-ROM: 1. Insert the CD-ROM into the CD-ROM drive in your computer. Step 5 of the previous section, Downloading the HumminbirdPCTM Software from the Website, will help guide you through completing the installation procedure. You will need to connect your PC to your Matrix unit using the PC Connect Cable and Power Cable included. Plug the PC Connect Cable into the Accessory connector on your Matrix unit. Plug the Matrix 9-Volt power cable, with a new 9-Volt battery connected to it, into the power connector on your Matrix unit. Note: The power cable shown in the illustration is for reference only, as the actual cable may differ from the illustration. The number of 9-Volt batteries used should match the number of terminations provided on the actual power cable. Note: A new 9-Volt battery will supply enough power to your Matrix unit to perform the programming and data transfer operations. The battery will have a short life if the Matrix unit is left on for a sustained period of time. To save the battery, make sure that the unit is only turned on when it is communicating with the PC during this procedure. Use the 4-Way Menu Control key to navigate to PC Connect, and select PC Connect using the right cursor key. Using the HumminbirdPCTM Software You will use the HumminbirdPCTM software to: Upgrade Matrix software Retrieve, display and personalize your Matrix unit profile Retrieve, store and edit waypoints, routes and tracks. As new features and accessories are introduced through our website www. Com, you can upgrade your Matrix using the HumminbirdPCTM software, similar to upgrading your PC drivers when adding a new peripheral device. The HumminbirdPCTM software will begin searching through the serial ports on your PC for a connection to the Matrix unit. the connection status will be displayed in the Status window. When your Matrix unit has successfully been located, the status will indicate "Connected! [. . . ] Put in your name, address and phone number, an inspirational message, or a goal for your next fishing trip!For more information, please use the built-in Help application. Your HumminbirdPCTM comes with built-in Help. The built-in Help feature is used to supplement the information found in this manual; there are many tasks described in the help that are not described in the manual. [. . . ]