User manual HUNTER 30381

[. . . ] If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. ALWAYS UNPLUG the Air Purifier when it is not in operation, while the filter is being changed, and while it is being cleaned. [. . . ] Use the tip of a pen or pencil to press the reset button. AIR PURIFIER PARTS CONTROL AREA HOOK TAPE HEPAtech FILTER PREFILTER TM RECESS FOR FINGERS TO PULL OPEN FRONT GRILL GRILL VENTS FRONT GRILL Inside View of Front Grill TAB HOOK TAPE FIGURE 1A FIGURE 1B 41733-01 3 © 2005 Hunter Fan Company 41733-01_rev 02. 28. 05. pmd 3 2/28/05, 4:58 PM Using Your Air Purifier 1. Remove your air purifier from the box and take it out of the clear plastic protective bag. Place your HEPAtechTM Air Purification System on a firm, flat surface. Before turning the Air Purifier `on', you need to open the front grill. To release the front grill, place your fingers behind the tabs and pull forward. The filter will be installed in the correct position. Remove the plastic wrapping and replace the filter in the unit. The white filter material should be facing outward (towards you) and the wire mesh side should be hidden from view (inside the unit). Be sure that the bottom tabs are in location first, and then push the top of the grill forward until it is closed. The unit is now ready for normal operation. NOTE: This unit will not operate unless the door is placed in the correct position. Plug the unit into a 120V electrical outlet. Cleaning And Filter Replacement 1. Clean the outside of the unit with a soft, damp cloth. The front grill can be removed and cleaned in soapy water. At least every 90 days, open the front grill, remove the carbon pre-filter, and replace it. This is necessary to maintain proper odor-removing and overall filtration performance. If necessary, it can be changed more often. Mark the new filter installation sticker included with the new carbon pre-filter. Be sure to remove any plastic wrapping that may be on the new filter before you place it into the Air Purifier. While replacing the pre-filter, you should view the condition of the HEPAtech Filter. Compare the filter to the color coded chart that is on the inside of the housing. If the filter matches the dark color on the chart, you should remove the filter and replace it with a new filter. [. . . ] For the name of our nearest authorized Hunter Fan Company Service Centre, write to the Hunter Fan Company at the preceding address. You will be responsible for insurance and freight or other transportation to our factory service center. We will return the Air Purifier freight prepaid. The Air Purifier should be properly packaged to avoid damage in transit since we will not be responsible for any such damage. [. . . ]