User manual HUNTER 32517

[. . . ] The Care Free Humidifier Evaporative Humidifier ® ENGLISH ESPAÑOL FRANÇAIS See page 2 Vea la página 13 Consulter la page 25 Features (Vary By Model): NiteGloTM Night Light Digital Humidistat Automatic Shut-Off www. hunterfan. com 41744 04/27/2006 1 ©2006 HUNTER FAN CO. 41744_booklet_04-27-06. indd 1 4/27/06, 9:08:55 AM READ AND SAVE THESE INSTRUCTIONS Important Safety Instructions: Read all instructions before using this humidifier. 1. This humidifier may not work properly on an uneven surface. ALWAYS place this humidifier on a firm, level, and water resistant surface. ALWAYS place the humidifier at least six (6) inches away from walls and heat sources such as stoves, radiators, or heaters. [. . . ] When the water tank is empty, the humidifier will automatically shut itself off. The red light will be illuminated, indicating that the water tank needs to be refilled. Follow REFILLING THE WATER TANK directions. Once the water tank is refilled, the Refill Light will not be illuminated. Only for models with a NiteGloTM Night Light 12. Use the control to turn the night light off and on. The night light can be operated even if the humidifier fan is turned `OFF'. ENGLISH 41744-01 04/27/2006 5 ©2006 HUNTER FAN CO. 41744_booklet_04-27-06. indd 5 4/27/06, 9:08:59 AM Using Your Digital Humidistat Setting the Desired Humidity NOTE: After unplugging the humidifier to move the humidifier, to refill the water tank or to clean the humidifier, you must reset the digital humidistat. Use the power/speed control knob to turn the humidifier `ON' by selecting a speed setting. NOTE: A speed setting must be chosen before the humidistat will operate the humidifier. In normal mode use the humidistat control buttons to set the desired humidity level. The settings range from 30% to 80% in 5% increments. When the humidity exceeds the level you have set, the humidistat light will go off. The humidifier will not output humidity while the humidity in the room is at the selected humidity level. The humidistat light will stay off until the humidity changes. When the humidity in the room drops below the selected level, the humidifier will cycle on again and the humidistat light will come on. Humidistat Light Setting the Span Refer to Figure 5. Your humidistat is set at the factory to cycle at setting 2. If you find your system cycling too fast or too slow, then the span can be adjusted to modify the cycle time. Press and hold both humidistat control buttons for two seconds to enter span setting mode. In span mode, use the humidistat control buttons to adjust the span. Raise the span to 3 to increase the cycle time and allow your system to run longer. Lower the span to 1 to decrease the cycle time and allow your system to run shorter. The humidistat display will return to normal mode after keys are idle for 5 seconds. Humidistat Control Buttons Figure 4 Humidistat Control Buttons Figure 3 41744-01 04/27/2006 6 ©2006 HUNTER FAN CO. 41744_booklet_04-27-06. indd 6 4/27/06, 9:09:00 AM Refilling the Water Tank 1. [. . . ] Wipe the surfaces of the main housing with a soft cloth. Once all the parts are clean, reassemble the humidifier, and follow the USING YOUR HUMIDIFIER to continue use. If you are storing the humidifier, make sure the parts are completely dry, reassemble, and store in a dry location. Service Parts To obtain a service part for your humidifier, call customer service at 1-888-830-1326 or e-mail us at Techsupport@hunterfanhq. com. Please be prepared to tell the operator the model number of your humidifier and the name of the part you need to replace and the part number. [. . . ]