User manual HUNTER 36127

[. . . ] DO NOT tilt or move the Air Purifier while it is in operation. DO NOT immerse the Air Purifier in water as permanent damage will occur. Refer to and follow the CLEANING AND FILTER REPLACEMENT instructions. Introduction Thank you for purchasing the QuietFlo True HEPA Air Purifier from Hunter Fan Company. You have purchased our latest development in portable Air Purification Systems. [. . . ] Place the filter installation reminder sticker on the inside edge of the front grill. Circle the month and write the year of installation for the pre-filter and HEPA filter. Be sure that the bottom grill tabs are in position first, and then push the top of the grill forward until it is closed. The unit is now ready for normal operation. NOTE: This unit will not operate unless the door is placed in the correct position. Plug the unit into a 220~240V electrical outlet. ® HEPA Filter Pre-Filter Front Grill ;; ; @ 0 1 2 3 AIR PURIFIER PARTS Pre-Filter QuietFl o Filter Filter Reset HEPA Filter Quie tFlo Pre-Filter Filter Filter Reset 0 1 2 3 Pre-Filter Front Grill Buttons for opening the front grill Tabs for opening the front grill Figure 1 - Model 36095 Figure 2 - Model 36127 Hook Tape Figure 3 Grill Vents Hook Tape 41694_Purifier. indd 3 5/7/04, 5:10:09 PM 4 ® Operating Your Air Purifier On/Speed Control: Rotate the Speed Control knob to set the desired speed. A setting of zero (0) indicates that the unit is off, one (1) is low speed, two (2) is medium speed, and three (3) is high speed. The fan speed can be adjusted at any time. Pre-Filter and Filter Timers This air purifier contains timers that indicate when the pre-filter and filter should be changed. The timer automatically counts the number of hours that each filter has been in use. When the pre-filter counter reaches 2000 hours (approximately three months of use), the pre-filter indicator will be lit to show that the pre-filter should be changed. When the HEPA filter counter reaches 8000 hours (approximately one year of use), the HEPA filter indicator will be lit to indicate that the filter should be changed. The exact life of the pre-filter and filter will depend upon the environment. If necessary, the filters should be changed more frequently. To reset the pre-filter or filter timers when one indicator (or both) is lit: 1. Change the filter and/or pre-filter as described in the Maintenance section of the manual. To reset the counter to zero hours and turn off the indicator, simply press and hold the filter reset key for three seconds. If both the pre-filter and filter indicators are lit, the reset key will first turn off the pre-filter indicator. Then, you must release the reset key and then press and hold the filter reset key again for three seconds to turn off the filter indicator. To reset the pre-filter or filter timers before the indicators are lit: In some environments, you may want to change the pre-filter or filter more frequently than indicated by the filter indicators. This procedure allows you to reset the pre-filter or filter counter before the indicators are lit. Change the filter and/or pre-filter as described in the Maintenance section of the manual. Now, you must choose which timer you want to reset. Press and hold the filter reset key (approximately three seconds) until the pre-filter indicator flashes. [. . . ] If the filter matches the dark color on the chart, you should remove the filter and replace it with a new filter. Mark the new filter installation sticker included with the new QuietFlo HEPA Filter. Depending on use and environment, the HEPA Filter should last one year. ® ® 4. If you notice a decrease in air output or an increase in noise, the HEPA Filter may be clogged. [. . . ]