User manual HUSKY LINERS 47111

[. . . ] To aid in positioning and support of hinge plate during installation, insert one M12 X 70MM bolt into a driver's side tow hook mounting hole. The hinge plate can now be temporarily "hung" on the bolt (head of bolt will fit through hole in hinge plate). The hinge plate should be oriented with hinge boss towards passenger's side (see Photo 1). With hinge boss toward the passenger's side of vehicle, attach hinge plate and tow loop to passenger's side using the two M12 X 60 MM flange head bolts provided. [. . . ] Close swing arm slowly to striker plate. Adjust striker plate so that the latch pin is centered left to right in the rubber grommet in the swing arm and lift swing arm so that pin is just touching the bottom of the grommet. Tighten only the passenger's side M12 X 60MM bolts to 50 foot-pounds 12. Fully open and close the swing arm several times noting that latch pin/grommet alignment is still in place and latch is working properly. Make any needed adjustments and tighten passenger's side bolts to 75 foot-pounds. The final torque for the two passenger's side M12 X 60MM bolts is 100 foot-pounds. Mount the spare tire using the lug nuts provided. Open and close fully several times to insure the latch is operating smoothly and properly and the striker pin is centered in the swing arm grommet. With the added weight of the tire, it may be necessary to make a final adjustment to the striker plate. Tighten striker plate (driver's side--12M X 70MM) bolts to 100 foot-pounds 17. Refer to license plate wiring instruction sheet to finish installation. Photo 1 Photo 2 8" 4711 H2 Spare Tire Ca#116FA. doc NOTE: Your Hummer H2 tire carrier is manufactured using the highest quality materials. The hinge pin is stainless steel and the bushings are oil-impregnated bronze. We have included a grease fitting for supplemental lubrication if deemed necessary. License Plate Light Wiring Instructions 1. In front of rear bumper underneath vehicle on driver side, locate cluster of three plugs. The white plug housing should have no existing wiring. Remove the white plug housing from receptacle by pushing in the tab and pulling down. Remove the wire retainer from the plug housing. Remove the two orange plugs as shown in drawing. [. . . ] You will also find in your packaging a Jack Bracket Vibration Dampener (rubber bumper) that is used for vibration suppression. This bumper should be slid into place as shown in the photograph below. It should be located approximately 2" from the top of the wheel well and centered under the jack bracket. You will also find that once the inside spare tire carrier is removed, an open hole will be left inside the rear door trim panel where the tire carrier was attached (see photo 4). [. . . ]