User manual HUSKY LINERS 47902

[. . . ] Check to insure you have received all the above listed Contents and that no damage has occurred during shipping. Package 5mm Allen Wrench (Excursion) T-30 Torx Wrench (Excursion) T-50 Torx Wrench (Suburban) 8mm Allen Wrench (Suburban) 1- Handle Assembly 4- 3/8" X 3_" Hex Bolts 2- _" X 1" Nut Plates 1- Cargo Liner Retention Block 1- Cargo Liner 1- Drawer Liner (Foam) 2- 4" Square plates (Excursion) 2- M6 X 40 Allen Bolts (Excursion) 6- 3/8" Flat Washers 3) Position Storage Box top side down, placing it on a flat, non-marring surface. Remove shipping blocks and Channel Iron from bottom of drawer using Phillips Head Screwdriver. Removing block will allow drawer to slide out so use caution and avoid tilting Drawer Unit. [. . . ] Turn handle and note the position of the cam latch. The cam latch should be oriented on handle shank so that it will secure drawer unit when handle is horizontal on drawer (see note #2). Remove 3rd row seat from vehicle and fold second row seats forward. Suburban: Remove the two rear cargo tie-down loops from cargo area using a T50 Torx wrench. Position the two short 1" round spacers provided in the recesses where tie-down loops were removed. The storage box will later be positioned over these stand-offs and bolted into place. Excursion: Remove the four cargo tie-down loops from the cargo area. The two, 4" square plates will be bolted down at the rear locations later to mount storage box. Disconnect hinge stop lever on both rear doors by depressing spring and lifting lever from pin (see note #6). This will allow full door opening needed to slide Storage Box into cargo area. 9) Remove Access Panel from rear or Storage Box using 1/8" Allen Wrench and carefully slide drawer case into cargo area. 10) Insert one (1) of the 3/8" X 3_" Hex Bolts through each end of the channel iron. Screw a Nut Plate onto each of the 2 bolts a few turns (see note #3). 11) Position the Channel Iron over the front set of 3rd seat mounting rods. 12) Insert the remaining 3/8" X 3_" Hex Bolts through the remaining 2 holes, threading them into Nut Plates. The Nut Plates should be positioned so that they will be pulled against 3rd seat mounting rod when bolts are tightened. Do not tighten at this time (see note #8). Suburban: Install M10 X 60 Allen bolts through case and 1" round spacers and into threaded holes that held tie-down loops. Excursion: Install M6 X 40 Allen bolts through 4" square plates and into threaded holes that held the rear tie-down loops. 13) Position the two, 4" pieces of strap so that one piece is centered under each end of the Channel Iron (see note 4). [. . . ] The use or Armor All®, Son-of-a-Gun® or similar items is discouraged as the products make the liner slick. 20) Your Husky Storage Box comes with a limited one-year warranty. Winfield Consumer Products warrants its SUV Storage Box to be free from defects in material and workmanship of the product for one year, from the date of purchase, with proof of purchase. Cam Latch Detent Pin Note #1-Removing Detent Pin Note #2-Position Handle So Cam Latch will be pointing up when handle is horizontal. 4" Strap 8" Strap Note #3- 3/8 X 3_" Bolt through Channel Iron with Nut Plate attached. Note #4-4" Strap shown positioned under end of Channel Iron. [. . . ]