User manual HUSKY LINERS 47903

[. . . ] Check to insure you have received all the above listed Contents and that no damage has occurred during shipping. Package 5mm Allen Wrench (Excursion) 8mm Allen Wrench (Suburban) T-30 Torx Wrench (Excursion) T-50 Torx Wrench (Suburban) 1- Handle Assembly 1- Cam latch 1- Cargo Liner Retention Block 1- Cargo Liner 1- Drawer Liner (Foam) 4- _" Flat Washers 4- 4" Square plates (Excursion) 4- M6 X 40 Allen Bolts (Excursion) 3) Position Storage Box top side down, placing it on a flat, non-marring surface. Remove shipping blocks from bottom of drawer using Phillips Head Screwdriver. [. . . ] Align handle with holes (shank will pass through opening in drawer) and re-install the 10-32 flathead bolts/nuts using 1/8" Allen Wrench. On the inside of the drawer, re-install the spacer, cam latch and 3/8"-24 lock nut on handle shank, tighten nut only finger tight. Turn handle and note the position of the cam latch. The cam latch should be oriented on handle shank so that it will secure drawer unit when handle is horizontal on drawer (see note #2). Suburban: A) Mount "J" Strap to tapped hole in rear of box with 3/8" Bolt and Washer, do not tighten. B) Remove the two rear cargo tie-down loops from cargo area using a T50 Torx wrench. Position the two short 1" round spacers provided in the recesses where tie-down loops were removed. The storage box will later be positioned over these stand-offs and bolted into place. C) Carefully slide the storage box into cargo area while tipping the rear of box down to slide "J" hook under the 3rd seat handle. D) Install M10 X 60 Allen bolts through case and 1" round spacers and into threaded holes that held tiedown loops. E) Tighten 3/8" Bolt on "J" hook. Excursion: A) Remove the four cargo tie-down loops from the cargo area. The four, 4" square plates will be bolted down at these locations later to mount storage box. B) Disconnect hinge stop lever on both rear doors by depressing spring and lifting lever from pin (see note #6). This will allow full door opening needed to slide Storage Box into cargo area. C) Carefully slide the storage box into cargo area and install M6 X 40 Allen bolts through 4" square plates and into threaded holes that held the tie-down loops. [. . . ] The easiest way to clean the drawer liner or cargo liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. The use or Armor All®, Son-of-a-Gun® or similar items is discouraged as the products make the liner slick. 47903 11/17/2004 12) Your Husky Storage Box comes with a limited one-year warranty. [. . . ]