User manual HUSKY LINERS 47951

[. . . ] Remove the two plastic bumper surrounds from the ends of the bumper using a #30 Torx wrench. Depending on the year of Wrangler, there are 4 or 5 screws holding each surround. Save these screws, as they will be used later (see photo #3). Later in the installation process, you will reinstall the factory bumper surrounds or, you may choose to use the included Bumper End Plugs. [. . . ] flat washer in bottom of hinge pin and tighten. Remove the bottommost horizontal rubber bumper (only bumper not on tailgate) from your vehicle with T-30 Torx wrench (see photo 6). Place the provided _" plastic washer on the bolt you just removed and install bolt and washer back in the hole it came from to seal hole. -2- 47951 Wrangler Tire #140AE2. doc 15. Using provided _" X _" Allen bolt, mount the rubber bumper (removed in Step 14) to the inside swing arm upright (see photo 6). The tire mounting assembly can be mounted in 4 different positions, depending on individual preference and/or needs. Mounting with angle projecting upwards provides better departure ground clearance for larger tires. Mounting with angle projection downwards works best for smaller tires and/or better rearward vision. The mounting assembly can also be mounted with attachment plate on inside of swing arm uprights which moves the spare closer to the vehicle, or it can be mounted on the outside of the swing arm uprights which will provide more clearance for a wider tire or a wheel with a different offset (see photos 7 & 8). Whichever mounting position is chosen, the washer plates go on the opposite side of the upright as the mounting plate does. Install attaching bolts positioned with heads of bolts towards vehicle (threaded ends outward). If you will be mounting a Hi-Lift® or similar jack on your tire carrier, you will need to install the jack support upright in place of one of the washer plates. The included jack support upright mounts to the driver's side swing arm upright, situated so it is angling upwards (see photo 9). Note: It is important to have spare tire mounted before completing the next steps. If you will not be mounting a Hi-Lift® type jack on your Wrangler Tire Carrier, please skip to instruction step #18. If you will be mounting a Hi-Lift® type jack, thread the provided 3/8" X 2_" fully threaded bolt into the tapped hole in the jack support upright. Install bolt so threads project over bumper. Tighten bolt securely, then slide the 1" long round aluminum spacer (provided) onto this bolt. Secure jack to carrier by positioning jack foot (jack handle will be towards the swing arm upright) over the upward projecting mounting bolt on the swing arm. Maneuver jack over bolt just installed in jack support and secure by installing 3/8" flat washer, then hand knob. Place _" long round aluminum spacer over bolt passing through jack foot. Secure jack foot with 3/8" washer and hand knob (see photo 10 below). With spare mounted, slowly bring the swing arm toward the closed position. [. . . ] PHOTO 9 SHOWING JACK SUPPORT UPRIGHT WITH TOP SPACER IN PLACE TIRE MOUNT ASSEMBLY SHOWN MOUNTED WITH ANGLE UP. MOUNTING PLATE IS ON INSIDE OF SWING ARM UPRIGHTS. PHOTO 10 SHOWING MOUNTED JACK TOP HOLE IN JACK SUPPORT ALLOWS A PADLOCK TO BE USED TO SECURE JACK PHOTO 12. FACTORY BUMPER SURROUND PHOTO 11 SHOWING BUMPER END CAP. [. . . ]