User manual HUSKY LINERS 47952

[. . . ] 6) Remove drawer from the Storage Box and stand it vertically on its back wall (once again on a non-marring surface). Using a 1/8" Allen Wrench and 3/8" End Wrench, remove the two 10-32 flathead bolts and nuts from handle installation area. Note that there are spacers (thick washers) located between the front and rear extrusions that make up the drawer face. Should the spacers move out of position when the bolts are removed, 47952. doc 09/11/2006 reposition them before completing handle installation. [. . . ] If using a cleaner, 409® or Glass Plus® work well. The use or Armor All®, Son-of-a-Gun® or similar items is discouraged as the products make the liner slick. 47952. doc 09/11/2006 20) Your Husky Storage Box comes with a limited one-year warranty. Winfield Consumer Products warrants its SUV Storage Box to be free from defects in material and workmanship of the product for one year, from the date of purchase, with proof of purchase. 2000-2005 Ford Excursion: Remove the four cargo tie-down loops from the cargo area. The two, 4" square plates will be bolted down at the rear locations later to mount storage box. Disconnect hinge stop lever on both rear doors by depressing spring and lifting lever from pin (see note #6). This will allow doors to fully open so the Storage Box can be slid into the cargo area. 9) Remove Access Panel from rear of Storage Box using a 1/8" Allen Wrench. Carefully slide drawer case into cargo area. 10) Insert one (1) of the 3/8" X 3_" Hex Bolts through hole in either end of the channel iron. Screw a Nut Plate onto each of the 2 bolts a few turns (see note #3). 11) Position the Channel Iron over the front set of the 3rd seat mounting rods. 12) Insert the remaining 3/8" X 3_" Hex Bolts through the remaining 2 holes in the channel iron, threading them into Nut Plates (see note #8). The Nut Plates should be positioned so that they will be pulled against 3rd seat mounting rod when bolts are tightened. 13) Install M6 X 40 Allen bolts through 4" square aluminum plates and into threaded holes that held the rear tie-down loops. 14) Position the two, 4" pieces of strap so that one piece is centered under each end of the Channel Iron (see note 4). 15) Evenly tighten all bolts; do not over tighten. 16) Guide drawer back into drawer slides and re-insert detent pins. 18) Install Drawer Liner (foam) into drawer. 19) Install Cargo Liner by first centering liner on top of Drawer Unit. Then, insert the Cargo Liner Retention Block into the recess molded into the cargo liner. Using the Phillips Head Screwdriver, install the three #8 X 11/4" Stainless Steel Wood Screws through the holes in the Retention Block and into the top of the Storage Box (see note #5). [. . . ] The use or Armor All®, Son-of-a-Gun® or similar items is discouraged as the products make the liner slick. 13) Your Husky Storage Box comes with a limited one-year warranty. Winfield Consumer Products warrants its SUV Storage Box to be free from defects in material and workmanship of the product for one year, from the date of purchase, with proof of purchase. 47952. doc 09/11/2006 Cam Latch Detent Pin Note #1-Removing Detent Pin Note #2-Position Handle So Cam Latch will be pointing up when handle is horizontal. 4" Strap 8" Strap Note #3- 3/8 X 3_" Bolt through Channel Iron with Nut Plate attached. [. . . ]