User manual HUSKY LINERS 56091

[. . . ] DODGE DAKOTA FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install paint protection film before mud guard (see other side). Please read instructions thoroughly before installation. [. . . ] Adjust accordingly before tightening (Figure 1 and 2). Using mud guard as a template, mark, drill 1/8 holes and install #10 screws and washers at locations A and B. Using mud guard as a template, mark, drill 1/8 hole and install #10 screw and washer at location D, thru mud guard, fender liner and into a u-clip on the backside of liner. The u-clip is used as a nut, DO NOT clip over liner or sheet metal (Figures 1 and 2). PAINTING INSTRUCTIONS 1. Clean mud guard with a soap and water solution to remove dirt and other contaminates. Sand painting surface with 320 grit sand paper. 5609 Dodge Dakota Fro#19CB7. doc Rev: 0 PART NO. 3. Apply a coating of flexible primer-adhesion promoter. Apply a flexible paint as directed by the paint manufacturer 5609 PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing detergent. [. . . ] Using a sponge, squeegee any air bubbles and wrinkles from film. Allow film to dry before installing mud guard. 5609 Dodge Dakota Fro#19CB7. doc Rev: 0 [. . . ]