User manual HUSKY LINERS 5625FR

[. . . ] 99-02 GM TRUCK / 00-02 SUBURBAN, YUKON, YUKON-XL, TAHOE FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install paint protection film before mud guards (see other side). Please read instructions thoroughly before installation. [. . . ] Attach mud guard at location D with a #10 screw. Adjust accordingly before tightening screw. Center punch and drill a 1/8" hole at location E and fasten with a #10 screw. Install a fender washer and #10 screw at location C. NOTE: MUD GUARD WAS DESIGNED TO USE FACTORY FENDER HOLES WHERE POSSIBLE. If holes do not line up, place mud guard against fender, mark new hole locations onto the mud guard and drill a _" hole through mud guard. PAINTING INSTRUCTIONS 1. Clean mud guard with a soap and water solution to remove dirt and other contaminates. Sand painting surface with 320 grit sand paper. Apply a coating of flexible primer-adhesion promoter. Apply a flexible paint as directed by the paint manufacturer 5625 Front Instructions (2 SIDE Rev: 2 PART NO. PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS 5625 NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. 1. Position mud guard on fender to indicate placement location of paint protection film. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry. [. . . ] Using a sponge, squeegee any air bubbles and wrinkles from film. Allow film to dry before installing mud guard. 5625 Front Instructions (2 SIDE Rev: 2 [. . . ]