User manual HUSQVARNA (2008

[. . . ] 2008 Utility Vehicles Gasoline and Diesel Owner’s Manual HUV 4421-G / GXP HUV 4421-D / DXP NOTICE Warranty information appears at the end of this manual. No other warranties, express or implied, are contained herein. Your authorized representative checked the vehicle before it was delivered to you and will provide you a copy of the completed vehicle warranty registration form. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. [. . . ] Do not allow this solution to enter the battery. Let the terminals dry and then coat them with Battery Terminal Protector Spray (P/N 603 00 00-03). Adjust the tires to the recommended tire pressure. Perform semiannual periodic lubrication. See Periodic Lubrication Schedule on page 33. Thoroughly clean the front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle. Chock the wheels to prevent the vehicle from rolling. RETURNING THE STORED VEHICLE TO SERVICE 1. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Restore the fuel system to operation (Figure 33 or Figure 34, Page 44). Remove the plug from the fuel tank vent. Connect the vent tube to the fuel tank vent. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat terminals with Battery Terminal Protector Spray (P/N 603 00 00-03). Gasoline vehicles only: Completely open the fuel shut-off valve (Figure 12, Page 28). A partially closed fuel shut-off valve combined with the use of the choke can result in a fouled spark plug and engine failure (Figure 13, Page 28). Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor (gasoline vehicles) and the fuel lines (all vehicles) and the engine starts. NOTE: Due to the oil added to the gasoline engine in preparation for storage, the engine may smoke excessively for a short time when it is run for the first time after storage. Perform the Pre-Operation and Daily Safety Checklist on page 18 and the Performance Inspection on page 19. MAINTENANCE See General Warnings on page 9. To ensure trouble-free vehicle performance, follow an established preventive maintenance program. Regular and consistent maintenance can prevent vehicle downtime and expensive repairs. Use the Pre-Operation and Daily Safety Checklist on page 18, the Performance Inspection on page 19, and the following Periodic Service Schedule and Periodic Lubrication Schedule to keep the vehicle in proper working condition. Any vehicle not functioning correctly should not be used until it is properly repaired. [. . . ] (4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a warranty station* at no charge to the owner. (5) Notwithstanding the provisions herein, warranty services or repairs will be provided at all of our distribution centers that are franchised to service the subject engines or equipment. (6) The engine or equipment owner will not be charged for diagnostic labor that is directly associated with diagnosis of a defective, emission-related warranted part, provided that such diagnostic work is performed at a warranty station*. (7) Husqvarna is liable for damages to other engine or equipment components proximately caused by a failure under warranty of any warranted part. [. . . ]