User manual HUSQVARNA 125 E

[. . . ] Operator’s Manual 125E Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English CONTENTS Contents CONTENTS Contents . 3 SAFETY INSTRUCTIONS Personal protective equipment . 5 Checking, maintaining and servicing the machine’s safety equipment . 12 ASSEMBLY Assembling the loop handle . [. . . ] S Store the machine out of reach of children. S Only use original spare parts during repair. 11 KNOW YOUR EDGER 4 1 3 2 5 8 9 6 10 11 16 4 20 1 18 19 17 3 7 15 13 14 12 Know your edger 1. Blade Grease filler cap Bevel gear Blade guard Shaft Loop handle Throttle control Stop switch Throttle lock Cylinder cover Starter handle 12. Fuel tank Choke control Primer bulb Air filter cover Handle adjustment Locking nut Flat washer Spring washer Depth adjustment knob 2-stroke engine oil Operator’s manual (EPA) 21 22 12 ASSEMBLY NOTE: Make sure unit is assembled correctly as shown in this manual. Assembling the loop handle S Position the handle on the shaft. Note that the handle must be mounted between the two arrows on the shaft. While holding the screwdriver in position, remove locking nut by turning clockwise. Remove both washers (C and D) and the blade (B) from the output shaft. S Fit the screw, securing plate and wing nut as shown in the diagram. S Tighten the wing nut. B C D E Assembling the blade WARNING: The blade will continue to spin after the engine stops or after the throttle trigger has been released. To avoid serious injury, make sure the blade has stopped coasting and disconnect the spark plug before performing work on the blade. 5. Reinstall both washers and locking nut (counterclockwise). Tighten locking nut firmly with a wrench while holding screwdriver in position. If the blade binds against the shield, or appears to be uneven, the blade is not centered, and you must reinstall. WARNING: Wear protective gloves when handling or performing maintenance on the blade to avoid injury. The blade is sharp and can cut you even when it is not moving. WARNING: Under no circumstances should the edger be used without the blade guard installed. 1. Align hole in the dust cup with the hole in the side of the bevel gear by rotating the dust cup (A). Insert a small screwdriver into aligned holes. This will keep the output shaft from turning while loosening the locking nut (E). 13 FUEL HANDLING Fuel mixture CAUTION!The machine is equipped with a two-stroke engine and must always be run using a mixture of gasoline and twostroke engine oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture. S Always start by flling half the amount of the gasoline to be used. S Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank. WARNING: Gasoline Always ensure there is adequate ventilation when handling fuel. CAUTION!Always use high quality unleaded gasoline. S This engine is certified to operate on unleaded gasoline. [. . . ] (4) Additional damage to parts or components due to continued use occurring after any of the above. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HUSQVARNA SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON It is the Owner’s and Dealer’s responsibility to make certain that the Warranty Registration Card is properly filled out and mailed to Husqvarna Forest & Garden Company. This card should be mailed within ten (10) days from the date of purchase in order to confirm the warranty and to facilitate post-sale service. Proof of purchase must be presented to the authorized Husqvarna dealer in order to obtain warranty service. [. . . ]