User manual HUSQVARNA 128C

[. . . ] SERVICE 545196750 OM, 128L/C , 2009-02, 545196750 128 L, 128 C 545 19 67-50 CONTENTS Contents CONTENTS Contents . 3 SAFETY INSTRUCTIONS Personal protective equipment . 5 Checking, maintaining and servicing the machine’s safety equipment . 10 KNOW YOUR TRIMMER Know your trimmer . [. . . ] Stop the engine and trimmer head before you remove material that has wound around the drive shaft as otherwise there is a risk of injury. The bevel gear can get hot during use and may remain so for a while afterwards. Never lean over the cutting attachment guard. can be thrown up into the eyes causing blindness or serious injury. Keep unauthorized persons at a distance. Children, animals, onlookers and helpers should be kept outside the safety zone of 50 feet (15 meters). Stop the machine immediately if anyone approaches. S When cutting and sweeping you should use full throttle to obtain the best results. 545196750 Rev. 3 2/17/09 English--- 11 KNOW YOUR TRIMMER 1 2 3 128L 6 8 4 5 16 1 9 10 11 128C 7 15 13 14 12 4 1 17 18 Know your trimmer 1. Starter handle Fuel tank Choke control Primer bulb Air filter cover Handle adjustment Drive disc 2-stroke engine oil Operator’s manual (EPA) 19 545196750 Rev. 3 2/17/09 English--- 12 ASSEMBLY NOTE: Make sure unit is assembled correctly as shown in this manual. Fitting the trimmer guard and trimmer head (Model 128C) Fitting the loop handle S Position the handle on the shaft. Note that the handle must be mounted between the two arrows on the shaft. S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the wing nut (B). B A S Fit the screw, securing plate and wing nut as shown in the diagram. S Tighten the wing nut. C S Fit the dust cup (C) on the shaft. The nut must be completely covered by the dust cup. S Hold the dust cup with a wrench to prevent the shaft from rotating. S Screw the trimmer head (D) onto the shaft. Fitting the trimmer guard and trimmer head (Model 128L) S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (D). D B C D S To dismantle, follow the instructions in the reverse order. A A S Fit the drive disc (B) on the output shaft. S Turn the shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. [. . . ] This proof must include date purchased, model number, serial number, and complete name and address of the selling dealer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna dealer in a timely manner, no later than thirty (30) days from date of the operational problem or failure. The product must be delivered at the owner’s expense. Pick-up and delivery charges are not covered by this warranty. An authorized Husqvarna dealer can be normally located through the “Yellow Pages” of the local telephone directory or by calling 1-800-438-7297 for a dealer in your area. 7349 Statesville Road CHARLOTTE, NC 28269 English--- 22 U. S. [. . . ]