User manual HUSQVARNA 128CD

[. . . ] 3 SAFETY INSTRUCTIONS Personal protective equipment . 5 Checking, maintaining and servicing the machine’s safety equipment . 10 KNOW YOUR TRIMMER Know your trimmer . 13 Assembling and dismantling the two-piece shaft . [. . . ] Stop the machine immediately if anyone approaches. S When cutting and sweeping you should use full throttle to obtain the best results. 115275126 Rev. 1 9/15/09 English--- 11 KNOW YOUR TRIMMER 1 2 3 7 128LD 19 6 4 1 5 9 11 10 12 128CD 17 8 16 14 15 13 4 21 1 18 20 Know your trimmer 1. Starter handle Fuel tank Choke control Primer bulb Air filter cover Handle adjustment Drive disc Shaft coupling 2-stroke engine oil Operator’s manual (EPA) 115275126 Rev. 1 9/15/09 English--- 12 ASSEMBLY NOTE: Make sure unit is assembled correctly as shown in this manual. Dismantling: Fitting the loop handle S Loosen the coupling by turning the knob. S Position the handle on the upper shaft. Note that the handle must be mounted between the two arrows on the shaft. A S Press and hold the locking/release button (A). S While securely holding the engine and upper shaft, pull the attachment straight out of the coupling. S Fit the screw, securing plate and wing nut as shown in the diagram. S Tighten the wing nut. Assembling and dismantling the two-piece shaft Fitting the trimmer guard and Assembly: S Loosen the coupling by turning the knob. trimmer head (Model 128LD) S Position locking/release button (A) of attachment into guide recess (B) of coupling. A B S Push the attachment into the coupling until the locking/release button snaps into the primary hole (C). S Fit the correct trimmer guard (D) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (E). E F G C S Before using the unit, tighten the knob securely. D D S Fit the drive disc (F) on the output shaft. S Turn the shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. S Insert hex wrench (G) in the hole to lock the shaft. S Screw on the trimmer head (H) in the opposite direction to the direction of rotation. H WARNING: All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment instruction manual. Using the wrong hole could lead to serious injury or damage to the unit. S To dismantle, follow the instructions in the reverse order. 1 9/15/09 ASSEMBLY Fitting the trimmer guard and trimmer head (Model 128CD) S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the wing nut (B). B A C S Fit the dust cup (C) on the shaft. The nut must be completely covered by the dust cup. [. . . ] This proof must include date purchased, model number, serial number, and complete name and address of the selling dealer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna dealer in a timely manner, no later than thirty (30) days from date of the operational problem or failure. The product must be delivered at the owner’s expense. Pick-up and delivery charges are not covered by this warranty. An authorized Husqvarna dealer can be normally located through the “Yellow Pages” of the local telephone directory or by calling 1-800-438-7297 for a dealer in your area. 7349 Statesville Road CHARLOTTE, NC 28269 English--- 23 U. S. [. . . ]