User manual HUSQVARNA 140 S

[. . . ] Power Fuel tank capacity Oil tank capacity Ignition system Ignition advance Sparking plug Carburetter Chain lubrication Chain speed Saw chain Weight empty with 32 cm guide bar and chain 40 cm3 40 mm 32 mm 2. Oil filler cap Starter handle Starter Fuel filler cap Safety guard for chain brake Cylinder casing Choke control Stop contact Starting throttle ratchet Throttle safety catch Throttle lever 6. Fuel and chain oil Engine The saw is powered as the fuel. A petrol and oil mixture should be used 1. [. . . ] Fit a socket spanner on the clutch nut and turn until compression resistance is felt. Strike the handle of the socket spanner smartly – mind the saw body!Die Kupplungstrommel Nettoyez Ie tambour Place the drive sprocket on the clutch drum. Turn the drive sprocket so that the holes on the side face away from the drum. 21 Fit the drive sprocket on the engine shaft. When fitting, hold the drive sprocket in place with a finger or lift up the saw. Ie la — Screw the clutch onto the engine shaft (anticlockwise) fingertight only. When the saw is subsequently started the clutch will be automatically tightened. NOTE: Fit the chain and guide bar in place before starting. Changing the starter cord Back off the three starter the starter off. De la cordelette vis de fixation de Iancement du demarreur — 22 u  Take the cord out of the pulley. Remove the “cube” from the pulley with the aid of a small screwdriver. Ein neues Seil in die Seilscheibe Engagez une nouvelle cordelette 23 If necessary, use a small screwdriver the end of the cord out of the pulley. Remove the old cord from the starter handle. Remove the insert with the aid of a screwdriver. Utilisez un tournevis pour extraire de la poignee la piece bloquant la cordelette, puis separez cette piece de la cordelette. das Seil mit einem Faites un cordelette. Noeud Iockeren non serre Knoten versehen, de la a I’extremite Pull the knot into the insert, making sure pull it tight before it is inside the insert. Fit the insert in the starter Den Einsatz handle. De blocage Wind the cord onto the pulley. 26 When the cord is fully wound onto the pulley, pull it out about two turns. Check that the return spring does not “bottom”. [. . . ] Tension the chain, which should preferably have been left to soak in oil overnight on the guide bar (see “Fitting the guide bar and chain” on pages 34–36). If the chain has not been soaked in oil overnight it is advisable to dip it in oil before fitting it to the guide bar. Start the saw (see instructions for starting’ the saw on page 37). Run the chain for 3–4 minutes at half throttle. [. . . ]