User manual HUSQVARNA 185CD

[. . . ] Your emission control system includes Parts such as the carburetor and the ignition system. Where a warrantable condition exists, Husqvarna Forest & Garden will repair your small nonroad engine at no cost to you. Expenses covered under warranty include diagnosis, parts and labor. nearest authorized servicing dealer or call Husqvarna Forest & Garden at 1-800-487-5963. [. . . ] When replacing the any other part or any lubricant, always be sure to use only Husqvarna products or products which have been certified by Husqvarna for use with the Husqvarna product. In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact the nearest Husqvarna servicing dealer for assistance. Do not use any accessory or attachment other than those bearing the Husqvarna mark and recommended for the unit. Under no circumstances should you ever take apart the product or alter it in any way. Doing so might result in the product becoming damaged during operation or the product becoming unable to operate properly. TRANSPORTATION 5. Never put the machine down with the engine running unless you have it in clear sight. • Drain the fuel from the fuel tank before transporting or storing the blower. • Secure the blower so that it does nor receive damage from shock doing transportation. • Do not apply strong forces to the blower, such as throwing it or dropping it. Doing so in validates the warranty. STORAGE • When storing the blower, choose a space indoors free from moisture and out of the reach of children. 7 English What is what? 15 11 14 4 12 <170BT> 13 16 1 2 8 10 3 9 6 4 5 17 7 <170BF> 1. Volute Case 10. “CAUTION” Label 11. • Be sure to always tighten the buckle in front of your body. F11 WARNING • If you are not using a waist belt, be sure to remove it from the unit and store it. • There is a risk that the belt will be caught, toppling the unit. • There is a danger that the belt will be sucked into the fan. F12 11 English Fuel FUEL WARNING • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10ft (3m) away from the fueling point before starting the engine. • The engines are lubricated by oil specially formulated for aircooled 2-cycle gasoline engine use. If Husqvarna oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE) • Do not use BIA or TCW (2-stroke water-cooling type) mixed oil. RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1 • Exhaust emission are controlled by the fundamental engine parameters and components (i. e. , carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion. • These engines are certified to operate on unleaded gasoline. [. . . ] Remove and inspect the spark plug every 25 hours and clean the electrodes as necessary with a wire brush. The spark gap should be adjusted to . 025 in (0. 6 to 0. 7mm). • Plug manufacturers recommend replacing the plug twice a year to avoid unexpected plug failure in a job. REPLACEMENT PLUG IS A NGK CMR7H. F25 IMPORTANT • Note that using any spark plugs other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged. [. . . ]