User manual HUSQVARNA 21 MULTI CUT

[. . . ] Owner’s Manual Get it fixed, at your home or ours!Your Home For repair – in your home – of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it!For the replacement parts, accessories and owner’s manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters. [. . . ] CAUTION: Use only a replacement blade approved by the manufacturer of your mower. Using a blade not approved by the manufacturer of your mower is hazardous, could damage your mower and void your warranty. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. Make sure air filter and carburetor are up. Use a wood block between blade and mower housing to prevent blade from turning when removing blade bolt. NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth. Position blade on the blade adapter aligning the two (2) holes in the blade with the raised lugs on the adapter. Install the blade bolt with the lock washer and hardened washer into blade adapter and crankshaft. Use block of wood between blade and lawn mower housing and tighten the blade bolt, turning clockwise. If bolt needs replacing, replace only with approved bolt shown in the Repair Parts section of this manual. Blade adapter Lockwasher Blade Key Crankshaft keyway Blade bolt Hardened washer Trailing edge Crankshaft TO SHARPEN BLADE NOTE: We do not recommend sharpening the blade - but if you do, be sure the blade is balanced. an unbalanced blade will cause eventual damage to mower or engine. € The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower. • To check blade balance , drive a nail into a beam or wall. Leave about one inch of the straight nail exposed. Place center hole of blade over the head of the nail. if blade is balanced , it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced. GRASS CATCHER • The grass catcher may be hosed with water, but must be dry when used. € Check your grass catcher often for damage or deterioration. If catcher needs replacing, replace only with approved replacement catcher shown in the Repair Parts section of this manual. [. . . ] WARNING: Battery posts, terminals and • See manufacturer’s instructions for proper operation and installation of related accessories contain lead and lead accessories. Only use accessories apcompounds, chemicals known to the State proved by the manufacturer. Of California to cause cancer and birth • Stop the blade(s) when crossing gravel defects or other reproductive harm. € Stop the engine (motor) whenever you CAUTION: Muffler and other engine leave the equipment, before cleaning parts become extremely the mower or unclogging the chute. [. . . ]