User manual HUSQVARNA 225 H60

[. . . ] Operator's manual (EPA) 225H60 225H75 Please read these instructions carefully and make sure you understand them before using the machine. English SYMBOL EXPLANATION Symbols WARNING!Careless or incorrect use can result in serious, even fatal injury. Checks and/or maintenance should be carried out with the engine switched off, with the stop switch in the STOP position. Always use approved protective gloves. Read through the Operator‘s Manual carefully and understand the content before using the hedge trimmer. [. . . ] The machine is fitted with a two-stroke engine and must always be run on a mixture of gasoline and two-stroke oil. It is important to measure the quantity of oil accurately, to ensure the correct mixture ratio. Small discrepancies in the amount of oil have a great bearing on the proportions of the fuel mixture when mixing small amounts of fuel. Mixture • Always mix gasoline and oil in a clean container intended for fuel. • Always start by filling half the quantity of gasoline required. Fill the remaining quantity of gasoline. • Mix (shake) the fuel mixture carefully before filling in the machine‘s fuel tank. • If the machine is not used for a long period of time, the fuel tank should be emptied and cleaned. • This engine is certified to operate on unleaded gasoline. ! WARNING!Always provide good ventilation when handling fuel. Gasoline NOTE!Always use an oil-mixed quality gasoline (at least 87 octane). If your machine is equipped with a catalytic converter, ( an unleaded, oil mixed quality gasoline should always be used. A leaded gasoline will destroy the catalytic converter. • This engine is certified to operate on unleaded gasoline. • The lowest recommended octane rating is 87. If you run the engine on lower octane rating than 87 socalled “knocking“ can occur. This leads to an increased engine temperature, which can result in a serious engine breakdown. • When working at continuous high revs a higher octane rating is recommended. !The catalytic converter muffler gets very hot during and after use. Be aware of the fire hazard, especially when handling the saw near flammable substances or vapours. Fuelling WARNING!The following precautions reduce the risk of fire: Do not smoke or place any sources of heat in the vicinity of the fuel. Never refuel when the engine is running. Always stop the engine and let it cool for a few minutes before refuelling. [. . . ] speed , rear/front handles: Blades Type: Length, mm: Blade speed, Cut/min: 225H60 1, 55/25, 4 1, 34/34 1, 10/28 2 700 11 000-11 700 0, 9 kW/ 9 000 rpm Yes Yes 225H75 1, 55/25, 4 1, 34/34 1, 10/28 2 700 11 000-11 700 0, 9 kW/ 9 000 rpm Yes Yes Walbro MB/CD Champion RCJ 7Y 0, 02/0, 5 Walbro MB/CD Champion RCJ 7Y 0, 02/0, 5 Walbro WT 0, 85/0, 4 Walbro WT 0, 85/0, 4 12, 1/5, 5 12, 6/5, 7 95, 1 95, 1 2, 3/2, 0 3, 0/2, 3 2, 2/1, 5 2, 2/1, 5 Double sided 600 2 480 Double sided 750 2 480 Note 1: Equivalent sound pressure level is calculated as the time-weighted energy total for sound pressure levels under various working conditions with the following time distribution: 1/2 idle and 1/2 max. speed. 18 – English ´+H'o¶5:¨ EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (The US Environmental Protection Agency), Environment Canada and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 2001 and later small nonroad engine. and Canada, new small nonroad engines must be designed, built and equipped to meet the federal stringent anti-smog standards. Husqvarna Forest & Garden must warrant the emission control system on your small nonroad engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your unit. [. . . ]