User manual HUSQVARNA 235 E

[. . . ] The start/stop switch automatically returns to run position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance. Always wear approved protective gloves. Noise emission to the environment according to the European Community's Directive. The machine's emission is specified in chapter Technical data and on label. Regular cleaning is required. Visual check. Both of the operators hands must be used to operate the chain saw. [. . . ] Make sure there is plenty of ventilation when refuelling or mixing fuel (petrol and 2-stroke oil). Move the machine at least 3 m from the refuelling point before starting it. ! WARNING!Taking the following precautions, will lessen the risk of fire: Do not smoke and do not place any hot objects in the vicinity of fuel. Always stop the engine and let it cool for a few minutes before refuelling. When refuelling, open the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap carefully after refuelling. Always move the machine away from the refuelling area before starting. · 1 2 Never start the machine: If you have spilt fuel or chain oil on the machine. Wipe off the spillage and allow remaining fuel to evaporate. If you have spilt fuel on yourself or your clothes, change your clothes. Wash any part of your body that has come in contact with fuel. Never twist the starter cord around your hand. ! WARNING!Note the following before starting: The chain brake must be engaged when the chain saw is started to reduce the chance of contact with the moving chain during starting. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Otherwise the clutch can come loose and cause personal injuries. Make sure you have a secure footing and that the chain cannot touch anything. Keep people and animals well away from the working area. There is a simplified start reminder with illustrations to describe each step on the rear edge of the saw (A). As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved by disengaging the throttle lock. Disengagement is done by gently touching on the throttle trigger. This prevents unnecessary wear to the clutch, clutch drum and brake band. Starting The chain brake must be engaged when the chain saw is started. Activate the brake by moving the front hand guard forwards. Then let the machine idle for a few seconds before you apply full throttle. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. [. . . ] The bar should be turned regularly for more even wear. Check the lubrication hole in the bar, to be sure it is not clogged. If the bar has a sprocket tip, this should be lubricated. Check that the bar and chain are getting sufficient oil. [. . . ]