User manual HUSQVARNA 236 E

[. . . ] This product is in accordance with applicable EC directives. Symbols in the operator's manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. Always wear approved protective gloves. Noise emission to the environment according to the European Community's Directive. The machine's emission is specified in chapter Technical data and on label. Other symbols/decals on the machine refer to special certification requirements for certain markets. Visual check. Protective goggles or a visor must be worn. Refuelling. Filling with oil and adjusting oil flow. The chain brake must be engaged when the chain saw is started. Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. [. . . ] The fuel filter must be replaced at least once a year. Contamination in the tanks causes malfunction. Make sure the fuel is well mixed by shaking the container before refuelling. The capacities of the chain oil tank and fuel tank are carefully matched. You should therefore always fill the chain oil tank and fuel tank at the same time. ! · WARNING!Never use a machine with visible damage to the spark plug guard and ignition cable. A risk of sparking arises, which can cause a fire. Transport and storage Always store the chain saw and fuel so that there is no risk of leakages or fumes coming into contact with sparks or naked flames from electrical equipment, electric motors, relays/switches, boilers and the like. Always store fuel in an approved container designed for that purpose. For longer periods of storage or for transport of the chain saw, the fuel and chain oil tanks should be emptied. Ask where you can dispose of waste fuel and chain oil at your local petrol station. Ensure the machine is cleaned and that a complete service is carried out before long-term storage. Decompression valve (C): Press the valve to reduce the pressure in the cylinder and make starting easier. You should always use the decompression valve when starting the machine. Once the machine has started the valve will automatically return to its original setting. Pull the starter handle (D): Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly until the engine fires. B A D Decompression valve (C): Press the valve to reduce the pressure in the cylinder and make starting easier. You should always use the decompression valve when As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved 115 13 82-26 Rev. 1 2009-03-02 English ­ 21 STARTING AND STOPPING by disengaging the throttle lock. Disengagement is done by gently touching on the throttle trigger. This prevents unnecessary wear to the clutch, clutch drum and brake band. This method is very dangerous because you may lose control of the saw. · Allow the machine to idle a few seconds before giving full throttle. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. · Never start the machine indoors. Exhaust fumes can be dangerous if inhaled. [. . . ] Make sure that the chain catcher is undamaged, and replace it if necessary. The bar should be turned daily for more even wear. Check the lubrication hole in the bar, to be sure it is not clogged. If the bar has a sprocket tip, this should be lubricated. [. . . ]