User manual HUSQVARNA 236 E TRIO BRAKE

[. . . ] A protective helmet where there is a risk of falling objects Approved hearing protection Approved eye protection Regular cleaning is required. Speed of output shaft, rpm Always wear approved protective gloves. Other symbols/decals on the machine refer to special certification requirements for certain markets. Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. [. . . ] Otherwise you will be unable to control the brush cutter safely and this can result in injury to yourself or others. Never use a harness with a defective quick release. At the front is an easily accessible, quick release. Use this if the engine catches fire or in any other emergency Never start the machine: 1 2 If you have spilt fuel on it. Wipe off the spillage and allow remaining fuel to evaporate. If you have spilt fuel on yourself or your clothes, change your clothes. Wash any part of your body that has come in contact with fuel. Always use a quality petrol/oil mixture at least 90 octane (RON). If your machine is equipped with a catalytic converter (see chapter on Technical data) always use a good quality unleaded petrol/oil mixture. leaded petrol will destroy the catalytic converter. Use low-emission petrol, also known as alkylate petrol, if it is available. Always mix the petrol and oil in a clean container intended for fuel. always start by filling half the amount of the petrol to be used. Taking the following precautions, will lessen the risk of fire: Do not smoke or place hot objects near fuel. Always shut off the engine before refuelling. Always stop the engine and let it cool for a few minutes before refuelling. When refuelling, open the fuel cap slowly so that any excess pressure is released gently. tighten the fuel cap carefully after refuelling. Always move the machine away from the refuelling area before starting. Do not mix more than one month's supply of fuel at a time. If the machine is not used for some time the fuel tank should be emptied and cleaned. Always use a fuel container with an anti-spill valve. [. . . ] Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty. Remove the air filter cover and take out the filter. ensure that the filter is dry before refitting it. An air filter that has been in use for a long time cannot be cleaned completely. [. . . ]