User manual HUSQVARNA 322 E

[. . . ] 322E/325E-X Operator’s manual (CARB, EPA) Read through the Operator‘s manual carefully and understand the content before using the machine. 101 89 75-95 SYMBOL EXPLANATION Symbols WARNING!Careless or incorrect use can result in serious or fatal injury to the operator or others. • Arrows which show limits for handle mounting. • Always wear approved protective gloves. Read through the Operator‘s Manual carefully and understand the content before using the machine. [. . . ] The tightening torque of the locknut is 35 – 50 Nm. Remove the locking pin. A B C D 2. 3. 4. 5. 6. Assembling the angle gear • Assemble the angle gear back on the supporting tube. Turn the blade so that the drive shaft engages in the angle gear. Do not forget to remove the locking pin before using the machine. • Position the angle gear so that its slot is aligned with the line on the supporting tube. ! WARNING!Under no circumstances may the edge cutter blade be used without the blade guard fitted. • Firmly tighten the screw. English – 13 FUEL HANDLING Fuel mixture NOTE!The edger is fitted with two-stroke engines and must always be run on a mixture of gasoline and two-stroke oil. To ensure the correct mixture proportions it is important to measure the quantity of oil accurately. When mixing small amounts of fuel small discrepancies in the amount of oil has a great bearing on the proportions of the fuel mixture. Mixture • Always mix gasoline and oil in a clean container intended for fuel. • Always start by filling half the quantity of gasoline required. Fill the remaining quantity of gasoline. • Mix (shake) the fuel mixture carefully before filling in the machine‘s fuel tank. • If the clearing saw is not used for a long period of time, the fuel tank should be emptied and cleaned. • This engine is certified to operate on unleaded gasoline. ! Gasoline WARNING!Always provide good ventilation when handling fuel. NOTE!Always use high grade unleaded oil mixed gasoline (minimum 87 RON). Leaded fuel will destroy the catalytic converter and it will no longer serve its purpose. • This engine is certified to operate on unleaded gasoline. • The lowest recommended octane rating is 87. If you run the engine on lower octane rating than 87 so-called “knocking“ can occur. This leads to an increased engine temperature, which can result in a serious engine breakdown. • When working at continuous high revs a higher octane rating is recommended. ! [. . . ] speed rear/front handles: 2, 0/3, 5 5, 7/6, 0 531 00 40-44 503 84 65-01 1, 4/2, 6 6, 0/4, 4 531 00 40-44 503 84 65-01 Cutting equipment Blade Blade guard English – 21 FEDERAL AND CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (U. S. Environmental Protection Agency), CARB (California Air Resources Board) and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 1999 and later small off-road engine. In U. S. , new small off-road engines must be designed, built and equipped to meet the federal and California stringent anti-smog standards. Husqvarna Forest & Garden must warrant the emission control system on your small off-road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your unit. [. . . ]