User manual HUSQVARNA 359 G

[. . . ] Operator’s manual 357XP/XPG, 357XP E-tech 357XPG E-tech 359/G, 359 E-tech, 359G E-tech Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English KEY TO SYMBOLS Symbols on the machine: WARNING!Careless or improper use can result in serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: • • Approved protective helmet Approved hearing protection Chain brake, activated (right) Chain brake, not activated (left) Other symbols/decals on the machine refer to special certification requirements for certain markets. • Protective goggles or a visor Both of the operator′s hands must be used to operate the chain saw. The engine exhaust from this product contains chemical known to the State of California to cause cancer, birth defects or other reproductive harm. Never operate a chain saw holding it with one hand only. Symbols in the operator’s manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. Never let the guide bar tip come in contact with any object. [. . . ] Without a bar and chain attached to the chain saw the clutch can come loose and cause serious injury. Stopping • The chain brake should be activated when starting. Se instructions under the heading Start and stop. This method is very dangerous because you may lose control of the saw. The engine is stopped by pushing the stop switch to the stop position. • Never start the machine indoors. Exhaust fumes can be dangerous if inhaled. English – 21 WORKING TECHNIQUES Before use: • • To ensure that people, animals or other things cannot affect your control of the machine. To make sure that none of the above might come within reach of your saw or be injured by falling trees. , 1 2 3 4 5 6 7 8 9 Check that the chain brake works correctly and is not damaged. Check that the rear right hand guard is not damaged. Check that the throttle lockout works correctly and is not damaged. Check that the stop switch works correctly and is not damaged. Check that all handles are free from oil. Check that the anti vibration system works and is not damaged. Check that the muffler is securely attached and not damaged. Check that all parts of the chain saw are tightened correctly and that they are not damaged or missing. Check that the chain catcher is in place and not damaged. Follow the instructions above, but do not use a chain saw in a situation where you cannot call for help in case of an accident. 2 Do not use the machine in bad weather, such as dense fog, heavy rain, strong wind, intense cold, etc. Working in bad weather is tiring and often brings added risks, such as icy ground, unpredictable felling direction, etc. Take great care when removing small branches and avoid cutting bushes (i. e. cutting many small branches at the same time). Small branches can be grabbed by the chain and thrown back at you, causing serious injury. 10 Check the chain tension. General working instructions IMPORTANT!This section describes basic safety rules for using a chain saw. This information is never a substitute for professional skills and experience. [. . . ] Do not let the nose of the guide bar contact a log, branch, or any other obstacle which could be hit while you are operating the saw. Do not overreach or cut above shoulder height. Follow manufacturer’s sharpening and maintenance instructions for the saw chain. Only use replacement bars and chains specified by the manufacturer or the equivalent. Do not operate a chain saw when you are fatigued. [. . . ]