User manual HUSQVARNA 400 COMPUTER

[. . . ] Com manuals search engine This houshold sewing machine is designed to comply with IEC/EN 60335-2-28 and UL1594 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic safety precautions should always be followed, including the following: Read all instructions before using this household sewing machine. DANGER - To reduce the risk of electric shock: • A sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning. Replace bulb with same type rated 5 Watt. [. . . ] Otherwise the embroidery arm will not come to the park position to remove the unit from the machine. 30 Embroidery Using the Embroidery template When you wish to sew the embroidery at a speci c place on your fabric or garment, you can take advantage of the embroidery template to mark where the embroidery is to be sewn. In the Embroidery Booklet you will nd all the embroideries pictured in actual size. Place the template with the arrow pointing downward and matching the other marks. Draw the outer lines of your selected embroidery on the template using the template pencil. The markings can later be removed with an eraser. Place the template on your fabric where you wish to sew the embroidery. Draw marks on the fabric in the four grooves and in the center with your Pictogram™ pen. Place the embroidery hoop matching the arrow pointing downward to the arrow mark on the fabric. Insert the fabric into the hoop, see ”Embroidery hoop”, page 30. Make nal adjustments using the until the positioning buttons needle will start at the center. Snap on embroidery presser foot U, see page 27. Place the enclosed net over the thread spool. Thread the machine with embroidery thread as upper thread. In this case you need not place thread under the presser foot. Thread the bobbin thread according to "Threading" on page 12 and check to be sure the thread lies under the tension springs. Hint: Slide bobbin cover on, then cut thread. Always check there is enough bobbin thread before starting a new embroidery. The symbol ashing on the Infodisplay indicates if the embroidery card is not inserted or not inserted fully. The buttons 1-35 are used to select embroideries. Start sewing by touching the button or by pressing the foot control. The machine always starts from the center of the embroidery area, sews a starting stitch up to the beginning of the embroidery, sews a few stitches more, gives a ”beep” and stops. [. . . ] If this persists, contact your authorized Husqvarna Viking retailer. expert assistance The electronic overload protector may have switched off. Shut off the main switch, wait about a minute. Balance setting for buttonhole Balance can only be set if a buttonhole is selected. [. . . ]