User manual HUSQVARNA 4140G PARTS LIST

[. . . ] speed of output shaft, rpm Noise emission to the environment according to the European Community's Directive. The machine's emission is specified in the Technical data section and on label. This product is in accordance with applicable EC directives. Use unleaded or quality leaded petrol and two-stroke oil mixed at a ratio of 2% (1:50). Beware of thrown objects and ricochets. The operator of the machine shall ensure, while working, that no persons or animals come closer than 15 metres. [. . . ] Use low-emission petrol, also known as alkylate petrol, if it is available. Transport and storage S Store and transport the machine and fuel so that there is no risk of any leakage or fumes coming into contact with sparks or naked flames, for example, from electrical machinery, electric motors, electrical relays/switches or boilers. S When storing and transporting fuel always use approved containers intended for this purpose. S When storing the machine for long periods the fuel tank must be emptied. Contact your local petrol station to find out where to dispose of excess fuel. S Ensure the machine is cleaned and that a complete service is carried out before long-term storage. S The transport guard must always be fitted to the cutting attachment when the machine is being transported or in storage. S In order to prevent unintentional starting of the engine, the spark plug cap must always be removed during long-term storage, if the machine is not under close supervision and when performing all service measures. S The lowest octane recommended is 90. If you run the engine on a lower octane than 90, it can result in knocking. This gives rise to a high engine temperature, which can result in serious engine damage. S When working at continuous high revs, a higher octane rating is recommended. Two-stroke oil S For best results and performance, use HUSQVARNA two-stroke oil, which is specially formulated for our two-stroke engines. S If HUSQVARNA two-stroke oil is not available, you may use another two-stroke oil of good quality that is intended for air cooled engines. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. Discard a blade if cracks are found. S Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked. WARNING: The complete clutch, clutch cover, and shaft must be fitted before the machine is started, otherwise parts could come loose and cause personal injury. Always move the machine away from the refueling area before starting. Ensure the cutting attachment cannot come into contact with any object. Make sure no unauthorized persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 meters. Cold engine Primer bulb: Press the primer bulb 10 times until fuel begins to fill the bulb. The primer bulb need not be completely filled. S Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1. 5 Nm. The tightening torque of the locking nut should be 35- Nm. -50 Choke: Move the blue engine choke lever over to the closed position. S Check that the trimmer head and trimmer guard are not damaged or cracked. [. . . ] Replace the guard if it has been exposed to impact or is cracked. Check that the trimmer head is undamaged and not cracked. Check that the locking nut of the cutting equipment is tightened correctly. Check that there are no fuel leaks from the engine, tank or fuel lines. [. . . ]