User manual HUSQVARNA 4210G

[. . . ] 2008 HUV4210 Owner’s Manual Electric and Gasoline Utility Vehicles: HUV4210-G, HUV4210-E, HUV4210-GXP, and HUV4210-EXP NOTICE Warranty information appears on the last pages of this manual. No other warranties, express or implied, are contained herein. Please complete and return the warranty registration card included in this manual. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. [. . . ] See Periodic Lubrication Schedules on page 34. Thoroughly clean front body, rear body, seats, engine compartment, and underside of vehicle. Chock the wheels to prevent the vehicle from rolling. 6. 9. RETURNING THE STORED GASOLINE VEHICLE TO SERVICE 1. Restore fuel system to operation (Figure 31). Connect battery cables, positive (+) cable first, and tighten terminals to 144 in-lb (16 N·m). Completely open the fuel shut-off valve (Figure 17). A partially closed fuel shut-off valve combined with the use of the choke can result in a fouled spark plug and engine failure. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor and fuel lines and the engine starts. See following NOTE. NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a short time when it is run for the first time after storage. Adjust tires to recommended tire pressure. Perform the Pre-Operation and Daily Safety Checklist on page 20. MAINTENANCE See General Warnings on page 10. To ensure trouble-free vehicle performance, it is very important to follow an established preventive maintenance program. Regular and consistent vehicle maintenance can prevent vehicle downtime and expensive repairs that can result from neglect. Use the Pre-Operation and Daily Safety Checklist on page 20 and the following Periodic Service Schedules and Periodic Lubrication Schedules to keep the vehicle in proper working condition. Any vehicle not functioning correctly should be removed from use until it is properly repaired. This will prevent further damage to the vehicle and avoid the possibility of injury due to unsafe conditions. Contact your local Husqvarna distributor/dealer to perform all repairs and semiannual and annual periodic service. WARNING • If any problems are found during scheduled inspection or service, do not operate the vehicle until repairs are made. Failure to make necessary repairs could result in fire, property damage, severe personal injury, or death. • Only trained technicians should service or repair the vehicle or battery charger. Anyone doing even simple repairs or service should have knowledge and experience in electrical and mechanical repair. [. . . ] (4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a warranty station* at no charge to the owner. Page 56 2008 HUV4210 Owner’s Manual Warranties (5) Notwithstanding the provisions herein, warranty services or repairs will be provided at all of our distribution centers that are franchised to service the subject engines or equipment. (6) The engine or equipment owner will not be charged for diagnostic labor that is directly associated with diagnosis of a defective, emission-related warranted part, provided that such diagnostic work is performed at a warranty station*. (7) Husqvarna is liable for damages to other engine or equipment components proximately caused by a failure under warranty of any warranted part. (8) Throughout the engine or equipment warranty period stated above, Husqvarna will maintain a supply of warranted parts sufficient to meet the expected demand for such parts. [. . . ]