User manual HUSQVARNA 4421GXP

[. . . ] 2008 HUV 4421 Owner’s Manual 4421-G/GXP/GXL Gasoline and 4421-D/DXP/DXL Diesel Utility Vehicles NOTICE Warranty information appears at the end of this manual. No other warranties, express or implied, are contained herein. Your authorized representative checked the vehicle before it was delivered to you and will provide you a copy of the completed vehicle warranty registration form. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. [. . . ] • Gasoline vehicles only: Turn fuel shut-off valve to the closed (OFF) position (Figure 13). • Do not attempt to charge frozen batteries or batteries with bulged cases. Frozen batteries can explode. CAUTION • Batteries in a low state of charge will freeze at low temperatures. Page 30 2008 HUV 4421 Owner’s Manual Storage 3 1 2 1. Open (ON) NOTE: When selecting valve position, ensure that it is fully opened or fully closed. 449 Figure 13 Fuel Shut-off Valve PREPARING THE VEHICLE FOR EXTENDED STORAGE 1. Unload the vehicle so that the tires are supporting only the weight of the vehicle. This will minimize battery self-discharge. If the battery appears to be weak, have it charged by a trained technician. Use an automotive-type 12-volt battery charger rated at 10 amps or less. Check electrolyte level after charging and add distilled water if necessary. If the battery is dead, see Using A Booster Battery (Jump Starting) on page 52. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Gasoline vehicles: Prepare the fuel tank. Following the manufacturer’s directions, add a commercially available fuel stabilizer (such as Sta-Bil®). Run the engine in a well-ventilated area to allow treated fuel to replace untreated fuel in the carburetor. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 33). Plug the fuel tank vent nipple so that it is air tight. Husqvarna recommends using a slip-on vinyl cap. Remove both spark plugs, and pour 1/2 ounce (14. 2 mL) of SAE 10 weight oil through each of the two spark plug holes. Rotate the engine crankshaft by hand several times, then install both spark plugs. Diesel vehicles: If Biodiesel fuel is used, see Biodiesel Fuel (Diesel Vehicles Only) on page 48. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 34). Plug the fuel tank vent nipple so that it is air tight. [. . . ] (4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a warranty station* at no charge to the owner. 2008 HUV 4421 Owner’s Manual Page 61 Warranties (5) Notwithstanding the provisions herein, warranty services or repairs will be provided at all of our distribution centers that are franchised to service the subject engines or equipment. (6) The engine or equipment owner will not be charged for diagnostic labor that is directly associated with diagnosis of a defective, emission-related warranted part, provided that such diagnostic work is performed at a warranty station*. (7) Husqvarna is liable for damages to other engine or equipment components proximately caused by a failure under warranty of any warranted part. (8) Throughout the engine or equipment warranty period stated above, Husqvarna will maintain a supply of warranted parts sufficient to meet the expected demand for such parts. [. . . ]