User manual HUSQVARNA 500 HD56 EL

[. . . ] The machine has been constructed according to the latest technology and in accordance with the recognised technical safety regulations. Nevertheless, use of the machine can involve risks to the user or third persons, and can cause damage to the machine or other objects. Attention: Using electric power tools, you must observe following fundamental safety instructions to protect yourself against electric shock, against danger of injuries and danger of fire. Read all these instructions before using the hedge trimmer and observe them. [. . . ] Take care when transporting the equipment (only with blade cover!For initial use of the hedge trimmer we would recommend that in addition to reading the operating instructions, you also seek a practical demonstration from an expert. Always ensure that all protective devices and handles are properly fitted. Never attempt to use an incomplete machine. The use of the hedgetrimmer is to be avoided if other persons, above all children, are within the working area. Familiarize yourself with the working area and pay attention to possible dangers which you Might not be able to hear due to the noise of the machine. 1) The bow-type handle must be pulled over the blade system from below as shown in Fig. 1 and then set into the relief of the hedge shears housing. In doing so, one must not push the two parts of the bow-type handle together. To fix the bow-type handle the two included screws must be screwed into the threadings in the housing through the openings of the handle and fastened tightly. 2) Slide the handguard onto the handguard plate at the front side of the housing until it effectively locks into place. Power connection The machine can only be connected to a single-phase a. The machine is protectively insulated in accordance with classification II of VDE 0740 and can therefore be connected to sockets without earth connections. Before using the machine ensure that the mains current agrees with the operating voltage data on the machine's identification plate. Power Circuit Breaker: Machines which will be used in different outside locations must be connected to a Power Circuit Breaker. 3) Only use cables (extension flex) that are approved for outdoor use. The cable diameter must be equal to or bigger than 1. Put the coupling of the extension flex onto the shears` plug. For strain relief, stick a loop of the extension flex through the opening in the handle and put it onto the strain relief hook. After finishing work, slide the loop ahead over the hook and pull it back through the handle opening. Extension flexes with a length of more than 30m reduce the machine's output. Do not use the trimmer in rain or for cutting wet hedges! [. . . ] Please use a lubricator that is not harmful to the environment , e. Then put the shears in their case with the cutting blades first. Holding the hedge trimmer when in use (Fig. 10) This equipment will enable you to cut or trim bushes and hedges easily and comfortably. [. . . ]