User manual HUSQVARNA 525RX

[. . . ] Operator’s manual Manuel d’utilisation Manual de instrucciones 525RX 525RXT 525RK Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English (2-31) French (32-63) Spanish (64-95) Downloaded from www. Careless or incorrect use can result in serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. [. . . ] Always move the machine away from the refueling area and source before starting. Mixing • • Always mix the gasoline and oil in a clean container intended for fuel. Always start by filling half the amount of the gasoline to be used. Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank. € • • • • • • Do not mix more than one month’s supply of fuel at a time. If the machine is not used for some time the fuel tank should be emptied and cleaned. Always use a fuel container with an anti-spill valve. Wipe off the spillage and allow remaining fuel to evaporate. Contamination in the tank can cause operating problems. Ensure that the fuel is well mixed by shaking the container before filling the tank. The catalytic converter muffler gets very hot during and after use. Be aware of the fire hazard, especially when working near flammable substances and/ or vapors. Com manuals search engine English – 17 STARTING AND STOPPING Check before starting Starting and stopping Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole. The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the teeth while sharpening or that the blade has been used with dull teeth. The complete clutch cover and shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury. Always move the machine away from the refueling area and source before starting. Ensure the cutting attachment cannot come into contact with any object. € Check that the support flange is not cracked due to fatigue or due to being tightened too much. discard the support flange if it is cracked. Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 meters (50 ft. Starting Cold engine (1) Air purge: Press the air purge repeatedly until fuel begins to fill the bulb. [. . . ] mANUFACTURER′S WARRANTY COVERAGE The emissions control system is warranted for two years. If any emissions-related part on your small off-road engine is defective, the part will be repaired or replaced by Husqvarna Forest & Garden. OWNER′S WARRANTY RESPONSIBILITIES • As the small off-road engine owner, you are responsible for performance of the required maintenance listed in your operator’s manual. Husqvarna Forest & Garden recommends that you retain all receipts covering maintenance on your small off-road engine, but Husqvarna Forest & Garden cannot deny warranty solely for the lack of receipts or your failure to ensure the performance of all scheduled maintenance. [. . . ]