User manual HUSQVARNA 532443089R1

[. . . ] Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. 2 Safe Operation Practices for WalkBehind Snow Throwers IMPORTANT: This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury. (f) Keep the nozzle in contact with the rim of the fuel tank or container opening at all times, until refueling is complete. [. . . ] Always check the engine oil level before start up. Firmly push in the primer (3) 2 times with your thumb, holding the primer in a for a second before releasing it each time. NOTE: Remove your glove when you push in the primer so that air cannot escape from the primer hole. IMPORTANT: It may not be necessary to use the primer or the choke if the engine has been running and is hot. Excessive priming may flood the engine and prevent it from starting. 3 2 Pull the recoil starter (5) or if your snow thrower is equipped with an electric starter, connect an extension cord to the snow thrower and plug the other end into a three-hole grounded 220 volt A. NOTE: Use an extension cord recommended for outdoor use that is not longer than 50 feet (15 m). The electrical cord can become damaged, causing a shock or fire. Thoroughly inspect the electrical cord before plugging it into a power source. If the cord is damaged, do not use it to start the snowthrower. IMPORTANT: Run the electric starter no more than 10 times at intervals of 5 seconds on, then 5 seconds off. Running the electric starter extensively can overheat and damage it. If the engine does not start after this series of attempts, wait at least 40 minutes to allow the starter to cool before attempting to start it again. If the engine does not start after the second series of attempts, take the snowthrower to an Authorized Service Dealer for service. NOTE: If you pull the recoil handle and feel no resistance, the starter may be frozen. Thaw out the starter before attempting to start the snowthrower. While the engine is running, move the choke lever (2) slowly to the right position. Unplug the extension cord from the power source and the snowthrower. Unplug the power cord whenever you are not starting the snowthrower. 4 Stopping the Engine 5 To stop the engine, pull key (1) out. 27 1 Engaging and Disengaging the Auger Blades To engage the auger blades, hold the control bar (1) against the handle. To disengage the auger blades, release the control bar (1). [. . . ] Do not store gasoline from one season to another. Replace your gasoline can if your can starts to rust. rust and/or dirt in your gasoline will cause problems. €¢ If possible, store your snow thrower indoors and cover it to protect it from dust and dirt. [. . . ]