User manual HUSQVARNA 532443568

[. . . ] Owner’s Manual 1830EXLT Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. Please read the owner's manual carefully and make sure you understand the instructions before using the machine. 532 44 35-68 English Safe Operation Practices for Walk-Behind Snow Throwers This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury. [. . . ] Purchase fuel in quantities that can be used within 30 days to assure fuel freshness. WARNING: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame. CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. ON / OFF SWITCH RECOIL (AUXILIARY) STARTER HANDLE GASOLINE FILLER CAP CHOKE CONTROL ENGINE OIL FILL CAP / DIPSTICK SCRAPER BAR (See Fig. 21) The scraper bar is not adjustable, but is reversible. After considerable use it may become worn. When it has worn almost to the edge of the housing, it can be reversed, providing additional service before requiring replacement. 22) Use the drift cutters to cut through deep snowdrifts that are higher than the front of the snow thrower. • Loosen adjustment nuts enough to allow drift cutter to be raised to highest position and tighten nuts securely. Repeat for opposite side of snow thrower. • When not using drift cutters, loosen adjustment nuts, lower to storage position and tighten nuts securely. AUGER HOUSING STORAGE POSITION DRIFT CUTTER ADJUSTMENT NUTS FIG. 22 STARTER BUTTON SAFETY IGNITION KEY PRIMER POWER CORD PLUG FUEL SHUT-OFF VALVE NOTE: ALL ITEMS ARE SHOWN IN THEIR TYPICAL LOCATION. ACTUAL LOCATION MAY VARY WITH ENGINE ON YOUR UNIT. 14 FIG. 23 OPERATION TO START ENGINE • Be sure fuel shut-off valve is in the “OPEN” position. Your snow thrower engine is equipped with both a 120 Volt A. C. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A. C. • Be sure your house is a 120 Volt A. C. [. . . ] Acidic gas can damage the fuel system of an engine while in storage. 21 TROUBLESHOOTING See appropriate section in manual unless directed to an authorized service center/department. Fuel shut-off valve (if so equipped) in OFF position. Throttle in STOP position (or ON/ OFF switch is OFF). Turn fuel shut-off valve to OPEN position. [. . . ]