Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HUSQVARNA 544921601. We hope that this HUSQVARNA 544921601 user guide will be useful to you.
Lastmanuals help download the user guide HUSQVARNA 544921601.
Detailed instructions for use are in the User's Guide.
[. . . ] Read this owner's manual carefully and know how to operate your snow thrower and how to stop the unit and disengage the controls quickly. Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction. Keep the area of operation clear of all persons, especially small children, and pets. [. . . ] Install the drive belt down between the hex bolt and the flat idler pulley with the flat side of the belt against the pulley. Loop the belt around the large v-pulley, placing it between the v-pulley and the hex bolt next to the pulley. HEX BOLTS FLAT IDLER PULLEY
(#46989)
DRIVE BELT
5/16" NYLOCK NUT (Y) 5/16" WASHER (Q) 5/16" x 3/4" HEX BOLT (C) TENSIONING CHAIN (JJ)
FIGURE 37 Did you choose the correct drive belt for your tractor?Using the wrong length belt may cause premature bearing or belt failure. STOP
FIGURE 35 STEP 36: (SEE FIGURE 36) • Assemble the cable bracket to the clutch/idler assembly using two 5/16" x 3/4" carriage bolts (K) and 5/16" nylock nuts (Y). Use the two front holes in the cable bracket if your tractor has a 42" mower deck. Use the two rear holes if your tractor has a 46" mower deck. 5/16" x 3/4" CARRIAGE BOLT (K) CABLE BRACKET
STEP 38: (SEE FIGURE 38) • Move the attachment clutch lever on the dash panel to the disengaged (down) position. Place the clutch/idler assembly on the floor on the right side of the tractor. Attach the tractor's clutch cable to the cable bracket. Secure the cable housing guide (groove down) to the cable bracket using the original collar and a 5/64" hair cotter pin (DD). The part number is printed on the outside of the belt . Set aside the belt that is not for your tractor to avoid accidentally using it. lEFT FRONT HOLE TENSIONING CHAIN (JJ)
55" BELT (PART #46989) TRACTOR TYPE DECK SIZE CLUTCH TYPE (LT) Lawn Tractor 38" , 42" , 46" Electric
FIGURE 42
56" BELT (PART #48138) TRACTOR TYPE DECK SIZE CLUTCH TYPE (LT) Lawn Tractor TABLE 2 48" Electric
20
STEP 45: (SEE FIGURE 44) • Turn the clutch/idler assembly right side up. Slightly loosen the hex bolt next to the flat idler pulley. Install the drive belt down between the hex bolt and the flat idler pulley with the flat side of the belt against the pulley. Loop the belt around the large v-pulley, placing it between the v-pulley and the hex bolt next to the pulley. Place the belt to the inside of the other flat idler pulley. HEX BOLTS FLAT IDLER PULLEY
STEP 47: (SEE FIGURE 46) • Assemble the drive belt onto the engine pulley and then onto the large pulley on top of the clutch/idler assembly. The belt must be placed to the inside of the idler pulley and the keeper bolt located beside the large pulley. Place tension on the belt by pulling the left side tensioning chain out as far as the 3/32" hairpin cotter (FF) will allow. Secure the chain in this position by inserting a 1/8" hairpin cotter (EE) through the chain. [. . . ] If a front mounted attachment is to be used, remove the side plates from the tractor. Be sure to assemble bolts back into the empty holes in the tractor frame. REMOVING THE SPIRAL AUGER HOUSING
• Lower the snow thrower to the ground. Lock the snow thrower's lift handle in the down position to decrease belt tension. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HUSQVARNA 544921601
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HUSQVARNA 544921601 will begin.
