User manual HUSQVARNA 5524 SEB

[. . . ] 5524SEB Owner's Manual IMPORTANT Safe Operation Practices for Walk-Behind Snow Throwers This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury. Look for this symbol to point out important safety precautions. WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. [. . . ] Insert safety ignition key into the ignition slot until it clicks. Keep the extra safety ignition key in a safe place. Place throttle control in FAST position. Push the primer four (4) times if the temperature is below 15°F/–10°C, or two (2) times if temperature is between 15° and 50°F/–10°C and 10°C. If temperature is above 50°F/10°C, priming is not necessary. NOTE: Over priming may cause flooding, preventing the engine from starting. If you do flood the engine, wait a few minutes before attempting to start and DO NOT push the primer. When the engine starts, release the recoil starter handle and slowly move the choke control to the OFF position. Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operating temperature. WARM START - RECOIL STARTER Follow the steps above, keeping the choke in the OFF position. BEFORE STOPPING Run the engine for a few minutes to help dry off any moisture on the engine. To avoid possible freeze-up of the starter, proceed as follows: 12 ELECTRIC STARTER 1. Plug the other end of the power cord into a three-hole grounded 120 Volt A. C. While the engine is running, push starter button and spin the starter for several seconds. NOTE: The unusual sound made while starter is spinning will not harm the engine or starter. Disconnect the power cord from the receptacle first, then from the engine. While the engine is running, pull the recoil starter handle with rapid, full arm strokes three or four times. NOTE: The unusual sound made while pulling the recoil starter handle will not harm the engine or starter. IF RECOIL STARTER HAS FROZEN If the recoil starter has frozen and will not turn the engine, proceed as follows: 1. Grasp the recoil starter handle and slowly pull as much rope out of the starter as possible. Release the recoil starter handle and let it snap back against the starter. [. . . ] 29 REPAIR PARTS WHEELS / DECALS 1 2 SNOW THROWER - MODEL NO. 961 93 00-10 5 4 6 4 5 4 3 6 2 4 1 10 2 4 9 8 6 5 1 10 3 30 7 REPAIR PARTS WHEELS / DECALS SNOW THROWER - MODEL NO. NO. DESCRIPTION 1 2 3 4 5 6 532 18 78-31 532 15 54-43 532 18 78-66 532 14 63-15 532 17 98-30 532 17 46-97 Wheel Assembly, 13", LH Pin, Klik 1/4 Wheel Assembly, 13", RH Screw, Hex Head 5/16-18 x 5/8 Bearing, Axle Washer, Thrust, 1" KEY PART NO. NO. DESCRIPTION 1 2 3 4 5 6 7 8 9 10 -- 532 18 10-38 532 19 13-77 532 18 10-34 532 18 10-41 532 19 85-82 532 18 10-32 532 15 57-98 532 15 58-00 532 18 10-36 532 15 57-94 532 40 37-59 Decal, Danger Decal, Husqvarna Decal, Danger, Deflector Decal, Danger Decal, Husqvarna, 5524SE Decal, Instruction Decal, Traction Lever Decal, Auger Lever Decal, Speed Control Decal, Husqvarna, Crown (2) Owner’s Manual NOTE: All component dimensions given in U. S. [. . . ]