User manual HUSQVARNA 600 H

[. . . ] I tjocka grenar, skall man slå av maskinen och dra ur kontakten ur uttaget, innan man undersöker och rättar till orsaken till fastkörningen. 11/ 6) Den utsträckta styrskenan förhindrar att obehagliga stötar (knivrekyl) överförs till användaren till följd av sammanstötning med solida föremål (vägg, mark, etc. Technical data Operating Voltage V~ Nominal Frequency Hz Nominal Consumption W Mains Safety Fuse A Cutting movements min -1 Shear length mm Cutting Thickness mm Weight (without flex) kg Noise Pressure Level LpA according to EN 50144 Vibration according to EN 50144 500HD 56EL 230 50 500 16 3600 560 22 3, 6 88 dB (A) <4, 7 m/s2 600HD 60EL 230 50 500 16 2400 600 27 3, 7 89 dB (A) <2, 4 m/s2 Machine noise information regulation 3, GSGV: the noise pressure level at the place of work can exceed 85 dB(A). Please observe the local regulations when operating your device. [. . . ] Only use extension leads which have been authorised for outside use. These flexes must not be lighter than PVC covered flex conforming to 227 IEC 53. Damaged cables of this unit are only to be replaced by a service station designated by the manufacturer as special tools are necessary. Equipment which will be used in different outside loca-tions should be connected via residualcurrent - operated current breakers. Ensure that the equipment is stored safely after use in such a way that the blade cannot be touched. When using the equipment, hold it securely with both hands, stand firmly and ensure that you have sufficient working space. There should be no people, animals or objects within the working area. Select the cutting height so that the blade does not make contact with the ground and you can operate the equipment from a secure position. Take care when transporting the equipment (only with blade cover!For initial use of the hedge trimmer we would recommend that in addition to reading the operating instructions, you also seek a practical demonstration from an expert. Always ensure that all protective devices and handles are properly fitted. These hedge shears have a two-hand safety switch. to switch the hedge shears on the bar switch in the handle (A) and the grip switch of the bow-type handle (B) must be pushed down. To switch the device off let go of both switches. The motor already stops if one of the two switches is released. To facilitate your work the hedgetrimmer model 600HD 60EL are equipped with a turning rear handle that can be set in 3 different positions (right, left, and normal). The purpose of this mechanism is that especially for cutting in vertical direction the hedge shears can be held in their ergonomically most favourable position whereby an early fatigue of the user is avoided. The handle is now unlocked and can be turned to the desired position (Fig. Please bear in mind that the locking pin (B) can only be pulled back when the switch (A) is not activated (held down). Make sure that the locking pin locks into place again after repositioning the turning handle. Only then the switch can be activated anew. The 5 special features two-hand safety switch, quick blade stop, protective cover, blade safety rail and impact protector are fitted to provide the hedge trimmer with optimum safety features. [. . . ] Sharpening of the blades The blades generally do not need servicing and do not require resharpening if used correctly. In order to prevent injuries caused by the blades when not in use, the sharpened cutting blade should be covered by the blade cover (Fig. The blades cannot be sharpened by the user without opening the equipment and the safety mechanism. Resharpening of the blades can therefore only be carried out at a specialist workshop. [. . . ]