User manual HUSQVARNA 650 CRT

[. . . ] 650CRT Owner's Manual SAFETY RULES Safe Operation Practices for Walk-Behind Powered Rotary Tillers TRAINING • Read the Owner’s Manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly. Never allow children to operate the equipment. [. . . ] Keep the engine free of grass, leaves, spilled oil, or fuel. Remove fuel from tank before tipping unit for maintenance. Clean muffler area of all grass, dirt, and debris. Do not touch hot muffler or cylinder fins as contact may cause burns. ENGINE LUBRICATION Use only high quality detergent oil rated with API service classification SF-SJ. Select the oil’s SAE viscosity grade according to your expected temperature. SAE VISCOSITY GRADES SAE 30 10W-30 / 5W-30 F C -30 -20 -20 0 -10 30 40 4 10 60 20 80 30 100 40 OIL DRAIN PLUG OIL LEVEL OIL FILLER PLUG TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE oil_visc_chart5_e(drt) FIG. 16 NOTE: Although multi-viscosity oils (5W-30, 10W-30, etc. ) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 40°F (4°C). Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 25 hours of operation or at least once a year if the tiller is not used for 25 hours in one year. Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil filler plug securely each time you check the oil level. 16 and 17) Determine temperature range expected before oil change. All oil must meet API service classification SF-SJ. • Be sure tiller is on level surface. • Oil will drain more freely when warm. • Use a funnel to prevent oil spill on tiller, and catch oil in a suitable container. For easier removal of plug use 7/16 12 Pt. socket with extension. ) • Tip tiller forward to drain oil. • After oil has drained completely, replace oil drain plug and tighten securely. Be careful not to allow dirt to enter the engine. See “CHECK ENGINE OIL LEVEL” in the Operation section of this manual. AIR FILTER (See Fig. 18) Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. [. . . ] Nut, Hex 3/8-24 Washer, Lock 3/8 KEY NO. 874 61 06-16 532 00 44-60 532 13 27-28 532 00 65-55 DESCRIPTION Bolt, Hex 3/8-24 x 1 Tine, Outer, R. H. Tine, Inner, R. H. NOTE: All component dimensions given in U. S. 1 inch = 25. 4 mm 25 REPAIR PARTS TILLER - - MODEL NUMBER 650CRT (650RTTB), PRODUCT NUMBER 954 32 91-72 DECALS 3 2 1 8 10 6 5 7 11 9 KEY NO. [. . . ]