User manual HUSQVARNA 675

[. . . ] Operator Manual LZ5227 / LZ7230 / LZ30 / LZ6130C / 968999674 968999676 968999776 968999752 LZ6130 / LZ6127 / LZ30C / LZ7230C / 968999675 968999709 968999751 968999753 Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English ©2007 HTC. Printed in U. S. A. CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Driving and Transport on Public Roads . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Move the steering controls to the neutral position (N). 8011-511-1 Released parking brake 3. Select the cutting height by placing the peg in the corresponding hole for desired height. Lock the peg in place on the inside with the pin. Squeeze the lock handle up to the lifting lever while moving the lever forward to meet the set peg. Make sure the work area is free from objects that could be thrown by the rotating blades. IMPORTANT INFORMATION The mower deck’s gauge wheels should be evenly adjusted. 8011-561 Select the cutting height 6. Engage the mower deck by pulling out the blade switch. The machine’s speed and direction are continuously variable using the two steering controls. When both controls are in the neutral position, the machine stands still. By moving both controls an equal amount forward or backward, the machine moves in a straight line forward or backward respectively. WARNING!Ensure that no one is near mower when engaging blade switch. English-32 8011-510 Engaging the mower deck OPERATION Operating on hills Read the Safety Instructions “Driving on Slopes” in the “Safety Instructions”. WARNING!Do not drive up or down hills with slopes greater than 10 degrees. Do not drive across slopes. • The slowest speed possible should be used before starting up or down hills. • Avoid stopping or changing speed on hills. • If stopping is absolutely necessary, pull drive levers into the neutral position and push to the outside of the unit and engage the parking brake. 8011-640 Stopping conditions IMPORTANT INFORMATION Control levers return to neutral when released. This may cause the mower to suddenly stop. • To restart movement, release the parking brake. • Pull the control levers back to the center of the mower and press forward to regain forward motion. • Make all turns slowly. 8011-511-1 Released parking brake English-33 OPERATION Mowing Tips • Observe and flag rocks and other fixed objects to avoid collisions. • Begin with a high cutting height and reduce it until the desired mowing result is attained. The average lawn should be cut to 2½" (64 mm) during the cool season and over 3" (76 mm) during the hot months. For healthier and better looking lawns, mow often after moderate growth. For best cutting performance, grass over 6" (15 cm) in height should be mowed twice. Make the first cut relatively high; the second to the desired height. • The mowing result will be best with a high engine speed (the blades rotate rapidly) and low speed (the rider moves slowly). If the grass is not too long and dense, the driving speed can be increased without negatively affecting the mowing result. • The finest lawns are obtained by mowing often. [. . . ] Normal wear, tear or abuse is not covered under warranty. Product must be returned to Charlotte with a warranty claim form. All care and maintenance instructions must be followed as stated by the manufacturer on the care label. The fit of the protective apparel/boot is not covered under warranty. [. . . ]