User manual HUSQVARNA 67521 HVE

[. . . ] 67521HVE Owner’s Manual 532 19 67-14 01. 13. 05 BY Printed in U. S. A. Safe Operation Practices for Walk-Behind Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Look for this symbol to point out impor tant safety precautions. CAUTION: Always disconnect spark plug wire and place wire where it cannot contact spark plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. [. . . ] For better grass bagging and most cutting conditions, the engine speed should be set in the fast position. Pores in cloth grass catchers can become filled with dirt and dust with use and catchers will collect less grass. To prevent this, regularly hose catcher off with water and let dry before using. Keep top of engine around starter clear and clean of grass clippings and chaff. This will help engine air flow and extend engine life. • • • • MULCHING MOWING TIPS IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF BUILT-UP GRASS /TRASH. SEE“CLEANING” IN THE MAINTENANCE SECTION OF THIS MANUAL. • TO STOP ENGINE • To stop engine, release operator presence control bar. • TO START ENGINE NOTE: Due to protective coatings on the engine, a small amount of smoke may be present during the initial use of the product and should be considered normal. To start a cold engine, push primer three (3) times before trying to start. This step is not usually necessary when starting an engine which has already run for a few minutes. Hold operator presence control bar down to the handle and turn the start key. IMPORTANT: Do not crank engine more than five continous seconds between each time you try to start. Wait 5 to 10 seconds between each attempt. • To start engine using the rope starter, follow the steps above. Exchange the use of the starter rope for start key. NOTE: In cooler weather it may be necessary to repeat priming steps. In warmer weather over priming may cause flooding and engine will not start. If you do flood engine, wait a few minutes before attempting to start and do not repeat priming steps. • The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to provide nutrients for the lawn. Always mulch with your highest engine (blade) speed as this will provide the best recutting action of the blades. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. At this time the grass has dried, yet the newly cut area will not be exposed to direct sunlight. For best results, adjust the lawn mower cutting height so that the lawn mower cuts off only the top one-third of the grass blades (See Fig. [. . . ] IMPORTANT: Use only Original Equipment Manufacturer (O. E. M. ) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty. ROTARY LAWN MOWER - - MODEL NUMBER 67521HVE (96143001100) - PRODUCT NUMBER 961 43 00-11 GEAR CASE ASSEMBLY - - PART NUMBER 532 18 82-94 KEY NO. 1 2 3 4 5 6 7 8 9 10 11 12 -- PART NO. 532 18 75-30 532 19 12-45 532 18 75-32 532 19 12-46 532 18 35-05 532 18 35-06 532 18 35-08 532 18 35-09 532 18 35-11 532 19 12-47 532 18 35-13 532 18 35-14 532 75 03-69 DESCRIPTION Case, Lower Case, Upper Gear, 24 Teeth Shaft, Worm Wireform Bearing, Ball Seal, Output Shaft Washer Bushing Shaft, Output Screw Seal, Worm Shaft Grease, Texaco Starplex Premium 1 (Do not substitute) (1. 4 ounce capacity) NOTE: All component dimensions given in U. S. [. . . ]