User manual HUSQVARNA 954140005C

[. . . ] Clear the area of objects such as rocks, toys, wire, etc. , which could be picked up and thrown by the blade. Be sure the area is clear of other people before mowing. Do not mow in reverse unless absolutely necessary. Always look down and behind before and while backing. [. . . ] Remove hex bolt, lock washer and flat washer securing blade. Install new or resharpened blade with trailing edge up towards deck as shown. 13 BATTERY Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life. • Keep battery and terminals clean. • Recharge at 6-10 amperes for 1 hour. IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY. • • Reassemble hex bolt, lock washer and flat washer in exact order as shown. torque). IMPORTANT: BLADE BOLT IS GRADE 8 HEAT TREATED. 15 CUSTOMER RESPONSIBILITIES TO CLEAN BATTERY AND TERMINALS Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. • Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor. • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush until bright. • Coat terminals with grease or petroleum jelly. • Turn ignition key “OFF” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TRACTOR TO REMOVE MOWER (See Fig. 15) Mower will be easier to remove from the right side of tractor. • Park tractor on a level surface and engage parking brake. • Be sure that attachment clutch lever is in “DISENGAGED” position. • Lower mower deck to lowest cutting position. • Remove retainer spring and washer that holds mower clutch spring to the mower clutch arm. • Disconnect mower clutch spring from mower clutch arm. • Remove retainer springs and washers from mower stabilizer link. • Remove retainer springs and washers from rear lift links. [. . . ] Decal, Handle Lift Manual, Owner's (English) Manual, Owner's (French) WHEELS & TIRES 1 KEY NO. 532059192 532065139 532124957 532123410 532106230 532059904 532008134 532142039 532141652 532104757 532124959 532171039 532144334 DESCRIPTION Cap, Valve Stem, Valve Fitting, Grease (Front Wheels Only) Tire, Front Tire, Rear Tube, Front (Optional Service Items Only) Tube, Rear (Optional Service Items Only) Rim, Front Rim, Rear Cap Axle Bearing Flange Washer 25/32 x 1-5/8 x 16 Ga. Tube) 2 6 5 8 4 4 5 5 4 3 9 7 6 6 7 8 9 -- NOTE: All component dimensions given in U. S. inches 1 inch = 25. 4 mm 42 SERVICE NOTES 43 SERVICE NOTES 44 SERVICE NOTES 45 WARRANTY STATEMENT SECTION 1: LIMITED WARRANTY Husqvarna Forest & Garden Company (“Husqvarna”) warrants Husqvarna product to the original purchaser to be free from defects in material and workmanship from the date of purchase for the “Warranty Period” of the product as set forth below: Lifetime Warranty: All tiller tines, trimmer shafts, ignition coils and modules on hand held product. [. . . ]